In drying with an oven the cakes are laid on edge on the shelves and the temperature of the oven is kept at about 100° F.; it should not exceed 104° F. The heat is provided by means of a bank of lamps placed under the hood and the current of warm air regulated by the size of the lamp bank and the openings in the top of the oven. Under no circumstances must an open flame be used as a source of heat. The drying in this case also is continued until successive weighings of samples show no appreciable loss. Whenever it is necessary to dry more than 50 pounds of guncotton primers for immediate use the guncotton should be placed in the drying oven and exposed to the action of an electric fan placed about 4 feet in front of the open door until the moisture content is reduced to about 6 per cent, when the drying should be completed by the use of the bank of lamps as described in the preceding paragraph. In each case, to test the dryness of the primers, take a cake and split it in four or five pieces and detonate each separately with a fuse. It has been determined that about 5 per cent of water is the maximum content for unconfined guncotton capable of detonation by a Du Pont No. 30 fuse. Priming charges are not to be prepared until just previous to the time they are to be used in loading. When the primers have been dried, they should be kept in well-sealed jars unless they are to be used very soon after drying, in which case they will be stored in assembled fuse cans; when thus stored the assembled fuse cans should be kept in a cool, dry, and secure room away from other explosives. If, however, the primers are to be stored for any length of time, two strips of blue litmus paper are inserted between the cakes, which are inspected from time to time. If the litmus paper shows decided redness, it should be removed and fresh strips inserted. If these strips turn red in a few hours, the primers should be thoroughly wet with fresh water. In general, the period of storage will be short and no particular examination of the dry guncotton will be required. Dry guncotton should be handled as little as possible, to prevent crumbling and scattering of guncotton dust. Finely divided guncotton is difficult to remove by brushing and if allowed to collect about a room may give serious trouble by flashing should a portion become ignited. This dust may be removed with a damp sponge or cloth. Dry guncotton which is not used as contemplated shall be rewet with the proper amount of water and repacked. Samples of each lot of guncotton issued to the service are preserved in the laboratory of the Ordnance Department for chemical test. These retained samples are subjected regularly to technical inspection and test by that department to determine their condition as to stability. This will insure the detection of lots that are deteriorating and their removal from the posts or their destruction before they have deteriorated to such an extent that they become dangerous.