CLEFT GRAFTING is generally done when the stock is larger than the scion, and also where the operation is performed at a point above the ground. The stock is split downward, after having been cut off at the point where the grafting is to be done. The knife should be sharp, and the bark should be cut through first, to avoid its being torn, and so that the sides of the cleft shall be smooth. A wedge is inserted to keep the cleft open for the insertion of the scion, which is cut on each side like a fine wedge; but the two planes not being parallel, the bark will be left on one side to the very point of the wedge, while on the other it will be removed a part of the way, making a feather edge, _A_, fig. 9. The object of this is to have the pressure of the cleft greatest upon the outer side, where the union is to be effected. It is well to have a bud on the strip of bark left between the two cuts used in forming the graft, this should be near the top of the cleft. One or two grafts may be inserted into a cleft, or more clefts may be made, in large stocks, or in re-grafting the large limbs of an old tree, but usually one is sufficient to leave growing; and in the young tree, only one should ever be allowed to remain. When the scion is nicely set into the cleft, so that the inner bark of the stock and graft shall coincide, or rather cross a very little, (see fig. 10,) the wedge, whether of hard wood, or of iron, should be gently withdrawn, and then the elasticity of the stock will hold the scion firmly to its place; this pressure should not be too severe. In this kind of grafting, if the pressure be sufficiently firm, and if the operation have been performed below the surface of the ground, it may not be necessary to make any other application than to press the moist earth about the parts, and cover all but the top of the graft with soil, and place a stick to indicate the plant and protect it from injury. If, on the contrary, the pressure of the cleft be not sufficient to hold the scion firmly, as in small stocks, the graft must be tied. For this a piece of bass matting, or cotton twine, may be used; and if the operation has been performed above ground, the whole must be covered with grafting wax, applied, either hot with a brush, or cold, after having been worked with the hands, or by wrapping with strips of muslin or paper previously spread with the wax. In old times grafting clay was used, and applied with the hands as a lump around the junction; but this disagreeable and clumsy appliance has given way to more elegant and convenient arrangements. [Illustration: Fig. 11--SIDE GRAFTING.] [Illustration: Fig. 12--SIDE GRAFTING--THE STOCK NOT CUT BACK.] [Illustration: Fig. 13.--TWO FORMS OF SIDE GRAFTING.--_A_, _B_, THE SCION AND STOCK FOR THE RICHARD SIDE GRAFT. _C_, STOCK FOR THE GIRARDIN SIDE GRAFT. _D_, SCION, AND _E_, FRUIT BUD FOR THE SAME.]