Casting menhaden bait from the rocky shores of the coast requires tools and tackle of great excellence and strength, as the largest bass are taken in this way. The most approved rod is a first-class split-bamboo, eight or eight and one-half feet long, and weighing from twelve to sixteen ounces. A more serviceable rod, that is, one that will admit of harder usage, is made of greenheart, lancewood, or bethabara, of the same length, but somewhat heavier. A cheaper rod, but one that will give good satisfaction, and withal is lighter than a wooden rod, is made of natural male Calcutta bamboo, and is known as a "chum" rod. Rods of eight or eight and one-half feet in length should be made in two or three pieces, or if not exceeding seven and one-half feet may be made of one six-foot piece with a handle of eighteen inches. They should have double bell-mouth guides and funnel top. The more expensive rods should have the guides, or at least the funnel top, lined with agate. The reel must be a first-class multiplier, made expressly for surf-fishing, with jewelled or steel bearings, with a capacity of two hundred yards of from twelve to eighteen-thread Cuttyhunk line. The hooks should be knobbed Sproat or O'Shaughnessy, Nos. 5-0 to 7-0, and attached to the line by two half-hitches, the loose end turned up and secured by another half-hitch. A long-handled gaff-hook of good steel and very sharp is indispensable. A chum knife and spoon are also necessary, and a woollen thumb-stall will be needed for thumbing the reel, or a piece of leather may be affixed to one of its bars as a brake. The bait for casting may be the tail of a lobster, cleaned of every vestige of shell, but menhaden bait is generally used. After scaling the fish, a slice of several inches is cut from its side, tail end, and scored on the flesh side longitudinally with a sharp knife, to admit of its being more readily folded along the hook, which it should envelop completely. The small end of the bait is affixed to the head of the hook by a half-hitch or two, its bend and barb being concealed by the broader end of the bait. This is the conventional method of baiting, though I have had good success in more southern waters by using an entire bait of mullet or other silvery fish, five or six inches in length, and hooked through the lips.