THE POSITION AND FIXING OF THE LOOMS. In a weaving shed the looms are driven from shafting running parallel to the looms when looked at lengthway. Drums on the line shafts drive the loom pulleys by means of straps. Of these pulleys there are two, generally about 9 inches diameter for a 40-inch loom. One pulley is loose on the shaft, the other keyed to it--the former to carry the strap when the loom is stopped. The looms are in groups of four, with an occasional row of couples for two or three loom weavers. The four arrangement is adopted for convenience to the weaver, as the looms having the starting ends contiguous, he has little walking for the purpose of setting on the machines. Thus, two “hands” of loom are required, those with the starting handle at the right-hand side being named right-hand looms, and _vice versâ_. There is little difference in construction--the crank-shaft is longer in one than the other for the purpose of having two straps on one driving drum. Many parts, such as crank-shafts, slays, shuttles, forks, brackets, etc., are required to be of two “hands,” each for its own hand of loom. In view of a case of having to remove looms or fix new ones, a few remarks on the general arrangements for fixing them may not be unacceptable. The line shaft runs over the space between the warp beams of the looms. A line must be marked on the floor with chisel or other convenient instrument parallel to this shaft and exactly below it. By dropping a plumbline from various parts of the shaft, the starting points can be obtained for stretching a line to mark from. The same arrangement is adopted at every third shaft, as the intermediate ones may be measured. From these lines the distance at which the loom feet are to stand may be measured, just leaving convenient space for getting between two full beams in each loom. The ends of the loom must be set parallel also, so that on looking down the shop a straight row of machinery will be observed. A line for setting the outside loom feet may be measured from the pillars, after getting the first pair of looms in suitable position. To test the accuracy of these measurements, the breast beam of each loom, as fixed, must be examined in a line with the breast beam of the previously deposited one. After the correct position is obtained, each loom must be levelled up by thin sheets of wood packing placed under the feet as required. Holes are then drilled in the floor, wood pegs inserted, and long iron nails driven home. A good passage round each group of four looms cannot be too greatly valued, and likewise a broad alley here and there running the whole length of the shed. LOOM TACKLING.