_The angle of site_ mechanism is designed to give the gun a maximum depression of about 6° and a maximum elevation of 11°, independent of the elevating mechanism. The mechanism is operated by two handwheels, one on each side of gun. [Illustration: 75 MM GUN CARRIAGE MODEL OF 1916. DIAGRAM OF ANGLE OF SITE MECHANISM.] Handwheel on right side operates through bevel gear on handwheel shaft and intermediate shaft, both mounted in angle of site bracket, right, and cross shaft mounted in bronze bushings in top carriage. Handwheel on left side operates through bevel gears on handwheel shaft, mounted in angle of site bracket, left, and cross shaft mounted in bronze bushings in top carriage. Bevel gears on ends of both cross shafts mesh with bevel gear on angle of site worm, which is mounted in bushings in top carriage and held in place by angle of site-worm caps. This worm meshes with teeth cut in rocker. Rocker is a U-shaped piece with bearings at the tops of both arms and teeth cut in bottom of U. The bearings bear over and are free to revolve about trunnions on cradle independent of trunnion bearing in top of carriage. Top half of right bearing is formed by rocker arm, right, which extends back and carries angle of site scale, pointer, rack, and level and forms a bearing for elevating handwheel shaft. Rear of rocker arm, right, is braced by rocker arm brace, a diagonal hollow rod attached to rocker arm and rocker. Top half of left bearing is formed by rocker arm, left, a diagonal arm extending upward to the rear to form a support for sight. Movement of the angle of site mechanism is limited in elevation by the rocker stop bolted to the side of the rocker and in depression by a screw in the arc. =The elevating mechanism= is designed to allow an elevation of the gun of 42° independent of the angle of site mechanism. The mechanism is operated by one handwheel on the right side of carriage, which is turned in a clockwise direction to elevate gun. [Illustration: 75 MM GUN CARRIAGE, MODEL OF 1916. ELEVATING MECHANISM.] The elevating mechanism is operated through bevel gears on elevating handwheel shaft mounted on a rocker arm, right, elevating intermediate shaft inside rocker-arm brace, elevating cross shaft, mounted in an elevating cross-shaft bearing bolted to the rocker, and the elevating worm, which bears inside lower part of the rocker. The elevating worm meshes with the elevating arc, which is bolted to the bottom of the spring cylinder. In indirect fire the angle of site in mils is laid off on the angle of site scale with the pointer and the desired range of graduation brought opposite the pointer by means of the elevating handwheel.