Fig. 1 is a front view of the testing chamber with transverse section of the shelter. Fig. 2 is a longitudinal section of the chamber along CD, and Fig. 3 a view, half in plan, half in section, along AB. The following are the references: M, backing wall; C, boiler; G, gas pipe; V, steam pipe; M, mortar; E, electric wires; A, shelter; RG, gasometer; ME, electrical machine; R', protective bank; R", backing of earth; R, glazed windows; S, apertures serving as valves; T, thermometer. * * * * * PHOTOGRAPHY FOR CHEMISTS. LANTERN SLIDES BY REDUCTION. When a negative happens to be of larger size than a quarter plate, it rarely happens that we can print a small portion by contact on a lantern plate without spoiling the composition of the picture. This is assuming, of course, that the operator has composed a picture and not put his camera down anywhere. There is no great difficulty in making lantern slides by reduction; the exposure is the only bugbear, as usual. There are two distinct methods of reduction: (1) daylight; (2) artificial light. There is nothing to choose between them, and the question of time and opportunity must decide which is to be adopted. The apparatus required is not expensive. It can be made in odd moments for a few pence, and is applicable to day and artificial light. It consists of a printing frame the size of the large negative, four pieces of bamboo a quarter of an inch in diameter, some black twill, the ordinary camera and lens, and a carrier to take lantern plates 3¼ X 3¼ inches. The negative is placed in the printing frame upside down and kept in position by four little slips of wood, or better still, a frame such as the gold slip used in picture frames, which will fit tightly into the frame and hold the negative securely. Of course, brads may be driven into two sides of the frame and the negative slipped behind them, but in this case it is necessary to safe edge the negative. This is done by cutting strips of tinfoil just wide enough to cover the rabbet of the negative so that no clear glass can be seen; these should be pasted and stuck on the glass of negative round the four sides. The strips of bamboo are either nailed to the printing frame or merely fastened together by stout copper wire, the shape being exactly that of the printing frame. The other end of the bamboos are tied with stout string to a piece of cardboard tube, postal tube, which slips over the lens. The length of the bamboos depends upon the focus of the lens and the amount of reduction. It will sometimes be found convenient to have the bamboo in two lengths; thus, supposing we want as a general rule 36 inches, two pieces, 24 inches each, should be obtained, and by fastening these together in the middle by two loose rings of copper wire we can extend them to 48 inches or reduce them to 24 inches.