_Second procedure._—For surface waters containing small amounts of organic matter, the method of Klut[59] is recommended. Samples containing small amounts of iron should be concentrated, if possible, until at least 0.5 mg. of iron is present in the volume tested. Boil the sample in a beaker with 2 to 3 cc. of concentrated nitric acid free from iron, adding permanganate if necessary to destroy the organic matter. To the hot liquid add ammonia in slight excess and warm until the smell of ammonia is hardly discernible. Filter and wash with water at 70° to 80° C. containing a little ammonia. Dissolve the iron in the beaker and on the filter paper in 5 cc. of concentrated hydrochloric acid, and wash with hot water until the iron is all dissolved, collecting the filtrate in a 50 cc. Nessler tube. Dilute to 50 cc. Add potassium sulfocyanide and determine the iron by comparison with standards. COMPARISON WITH IRON STANDARDS. _First procedure._—Prepare standards containing amounts of standard iron solution ranging from 0.05 to 4 cc. according to the quantity of iron in the sample. Dilute these amounts with water to about 40 cc. Add 5 cc. of dilute hydrochloric acid and 3 drops of potassium permanganate to each tube and dilute to 50 cc. Add 5 cc. of the potassium sulfocyanide to each of the standard solutions at the same time that it is added to the samples of water under examination, and compare immediately after mixing. If 100 cc. of the sample is used the iron in parts per million is equal to the number of cubic centimeters of the standard iron solution in the standard that the sample matches. _Second procedure._—For a small number of determinations it is more convenient to run the standard iron solution into a Nessler tube containing the acid, distilled water, and potassium sulfocyanide until the color matches that of the sample tested. When determining iron in three or four samples the colors may be matched in the order of their intensity and the volumes of standard iron solution required for each tube may be read from the burette. COMPARISON WITH PERMANENT STANDARDS. _Reagents._—1. Platinum solution. Dissolve 2 grams of potassium platinic chloride (PtCl_{4}.2KCl) in distilled water, add 100 cc. of concentrated hydrochloric acid, and dilute to 1 liter with distilled water. 2. Cobalt solution. Dissolve 24 grams of dry cobaltous chloride crystals (CoCl_{2}.6H_{2}O) in a small amount of distilled water, add 100 cc. of strong hydrochloric acid, and dilute to 1 liter with distilled water. _Procedure._—Prepare a series of permanent standards by diluting to 50 cc. with distilled water the amounts of platinum and cobalt solutions, in 50 cc. Nessler tubes, indicated in Table 9. Compare the sample with these standards, and calculate the parts per million of iron. Table 9.—PREPARATION OF PERMANENT STANDARDS FOR THE DETERMINATION OF IRON.