The Essentials of Illustration: A Practical Guide to the Reproduction of Drawings & Photographs for the Use of Scientists & OthersHill, Thomas George
Science
The Essentials of Illustration: A Practical Guide to the Reproduction of Drawings & Photographs for the Use of Scientists & Others
Hill, Thomas George
Engraving -- Printing; Illustration of books; Photomechanical processes
THE SWELLED GELATINE PROCESS. From the foregoing account of the
line-block it may, perhaps, be thought that a drawing shewing the
finest detail cannot be reproduced in the text by a relief block made
by photo-chemical means. This is not the case; the swelled gelatine
process is such that at its best the very finest work can be so
reproduced. The method is not extensively used, chiefly owing to the
remarkable amount of skill required to produce the best results and to
the facts that the blocks take longer to make and are more expensive
than the ordinary line block. This, however, should not militate
against its use, for the increased cost is but very little, and the
longer time in making, say two days, should not be of any consequence
in a monthly or quarterly periodical. The great point in its favour is
its great fidelity as compared with the ordinary photo-chemical relief
blocks: for instance, a close cross-hatching reproduced by a line
block will often come out as a series of white dots owing to the fact
that at the points of intersection the black lines tend to thicken;
hence, on printing, the white spaces, instead of being sharply cut and
diamond-shaped, are rounded. This will not occur in a good block made
by the swelled gelatine method. Further, the process does not restrict
the draughtsman to dead black ink; the drawings may be made in pencil,
crayon, or in ordinary writing ink: it is even claimed that wash
drawings and photographs can be reproduced satisfactorily by this
method. In the case of pencil drawings, the best results will be given
when the surface of the paper used by the draughtsman is slightly
rough; a pencil drawing on Bristol board, for example, will not be so
well reproduced as one on ordinary smooth drawing paper. In brief, the
process is as follows: a photographic negative of the drawing is made,
and under it is exposed a bichromate gelatine plate. This plate is
then developed in water. As already described, the gelatine will swell
up in proportion to the amount of light to which it was exposed. The
"positive" thus obtained will be in relief, the high lights being at a
higher level than the shadows. A wax mould of the gelatine positive
is then taken, covered with a thin layer of plumbago and electrically
covered with copper. The "casting" so obtained is built up with metal
and then mounted on wood in the same way as a zinco or a half-tone.
The capabilities of the process may be judged by a study of Fig. 38,
which is an extremely faithful reproduction of a lithograph, by S.
Prout, by the swelled gelatine process.
[Illustration: Fig. 38. A Lithograph by S. Prout reproduced by the
swelled gelatine process.]
[Illustration]
COST
RELATIVE COST OF BLOCKS AND PLATES
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Elsewhere in the archive
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account