Mr. Foster Ritchie, the clever inventor of this telautograph, had to provide for many things besides mere slavish imitation of movement. As has been stated above, the pen must record only those movements of the pencil which are essential. Evidently, if while the pencil returns to dot an _i_ a long line were registered by the pen corresponding to the path of the pencil, confusion would soon ensue on the receiver; and instead of a neatly-written message we should have an illegible and puzzling maze of lines. Mr. Ritchie has therefore taken ingenious precautions against any such mishap. The platen P on being depressed by the pencil touches a contact, X, which closes an electric circuit through the long-distance wires and excites a magnet at the receiving end. That attracts a little arm and breaks another circuit, allowing the bar Y to fall close to the paper. The wires FF’ and the pen are now able to rest on the paper and trace characters. But as soon as the platen P rises, on the removal of the pencil from the transmitting paper, the contact at X is broken, the magnet at the receiver ceases to act, the arm it attracted falls back and sets up a circuit which causes the bar to spring up again and lift the pen. So that unless you are actually pressing the paper with your pencil, the pen is not marking, though it may be moving. As soon as a line is finished a fresh surface of paper is required at both ends. The operator pushes the lever S sideways, and effects the change mechanically at his end. At the same time a circuit is formed which excites certain magnets at the receiver and causes the shifting forward there also of the paper, and also breaks the _writing_ current, so that the pen returns for a moment to its normal position of rest in the inkpot. It may be asked: If the wires are passing currents to work the writing apparatus, how can they simultaneously affect the lifting-bar, Y? The answer is that currents of two different kinds are used, a direct current for writing, a vibratory current for depressing the lifting-bar. The _direct_ current passes from the battery B through the rheostats RR’ along the wires, through the coils working the arms DD’ and into the earth at the far end; but the _vibratory_ current, changing its direction many times a second and so neutralising itself, passes up one wire and back down the other through the lifting-bar connection without interfering with the direct current. The message finished, the operator depresses with the point of his pencil the little push-key, K, and connects his receiver with the distant transmitter in readiness for an answer.