_Scuta_: these in young and moderately-sized specimens are striated, sometimes very faintly, but generally plainly, causing the lines of growth to be beaded; but often, in large and half-grown specimens, the lines of growth are extremely prominent, and being intersected by the radiating striæ, are converted into little teeth. As the striæ often run in pairs, the little teeth frequently stand in pairs, or broader teeth have a little notch on their summits, bearing a minute tuft of spines. In very old and large specimens, the prominent lines of growth are generally simply intersected by deep and narrow radiating striæ. In one case, a single zone of growth in one valve was quite smooth, whilst the zones above and below were denticulated. The valve varies in thickness, which I think influences the prominence of the lines of growth and the depth of the striæ. These striæ often affect the internal surface of the basal margin, making it bluntly toothed. The articular ridge is rather small, and moderately reflexed: the adductor ridge (as already stated,) varies remarkably; in most of the Panama specimens, it is extremely prominent, and extends down to near the basal margin; in other specimens it is but slightly prominent, especially in some of the fossil specimens from Virginia. The cavity for the lateral depressor, also, varies greatly; it is often bounded on the side towards the occludent margin by a very slight straight ridge, which occasionally folds a little over, making almost a tube; this, at first, I thought an excellent specific character, but far from this being the case, the cavity often becomes wide, quite open, and shallow. _Terga_, very slightly beaked; the surface towards the carinal end of the valve, in some of the fossil specimens, is very slightly striated longitudinally. There is either a slight depression, or more commonly a deep longitudinal furrow, with the edges folded in and touching each other, extending down the valve to the spur, and causing the latter to vary in width relatively to its length. When the furrow is closed in, the spur is about one fourth of the entire width of the valve, and has its lower end obliquely rounded, and stands at about its own width from the basi-scutal angle: when there is only a slight depression and no furrow (as is always the case with young specimens), the spur is broader, equalling one third of the width of the valve, with its lower end almost truncated, and standing at about half its own width from the basi-scutal angle. But the absolute length of the spur, also, varies considerably; it is often very long, compared to the whole valve. The basal margin on the carinal side is sometimes slightly hollowed out; when the furrow is closed, this latter side slopes towards the spur. Internally, the articular ridge and crests for the tergal depressor muscle are moderately prominent.