The opercular valves are added to along their basal margins alone;[23] the animal's body, together with the several muscles, becoming attached at each period of growth lower and lower down to the valves; this no doubt is effected by the absorption of the upper surfaces of the muscles, and the formation of new fasciæ on their lower surfaces. The opercular membrane, which, though thin and flexible, forms part of the general outer surface of the animal as much as does any portion of the rigid shell, with which indeed it is strictly homologous, is periodically moulted, together with the integuments of the whole included animal. The new opercular membrane is of course each time formed a little larger than the old one. In Coronula and Tubicinella, however, several successive opercular membranes are preserved one over the other, and the outside membrane gradually disintegrates; in these cases the undermost opercular membrane is formed wrinkled and considerably too large, so as to allow of being stretched, before it is finally cast off. In Tubicinella, the opercular membrane runs down, adhering to the inner surface of the shell, to nearly the basis, and hence during the diametric growth of the shell, it is longitudinally split, and is repaired by slips of new membrane, which resemble the radii in form and in direction of the lines of growth. [23] In some species of Pyrgoma, the ledge (_limbus occludens_) which is added along the occludent margin of both scuta and terga, and in some species of Balanus a narrow rim, or slight protuberance which is added along the carinal margin of the terga, offer unimportant exceptions to the rule, that the opercular valves grow only at their basal margins.