_Preparation of Standard Acid and Alkaline Solutions._--In practice it is very difficult to obtain perfectly pure caustic soda, free from water and carbonic acid, both of which are greedily absorbed by it from the air, so that a standard solution cannot practically be made by directly weighing out the substance as suggested in the introductory paragraph. In sodic carbonate, however, we have a substance which is easily obtained pure and dry, and which may be used for almost all the purposes to which a caustic solution could be applied. A decinormal solution is strong enough for most of the work in a tannery, though it is a convenience to have both normal and decinormal, and a stock of the stronger solution will last a longer time and is readily diluted to decinormal strength by adding 1 part to 9 parts of distilled water. To make a normal solution, about 60 _grm._ of the purest sodic carbonate are placed in a porcelain basin or platinum crucible and heated over a Bunsen gas-burner or spirit-lamp, nearly to redness, and allowed to cool closely covered up. Of the salt thus dried 53 _grm._ are accurately weighed into a beaker and dissolved in distilled water. The solution is then poured into a gauged _litre_ flask, and carefully filled up with water at a temperature of 59° F. (15° C.) to the mark on the neck. The whole is then poured into a good-sized stoppered bottle (40 oz.) and vigorously shaken for 5-10 minutes. This thorough shaking is important with all standard solutions, and without experience no one would believe how much shaking is required uniformly to mix a solution. Probably more difficulty to beginners in analysis arises from neglect of this matter than from any other cause. To make a decinormal solution, proceed in precisely the same way, using 5·3 _grm._ instead of 53; or dilute as above. _Standard Acid Solution._--For this purpose any one of several acids may be used, each of which has its special advantages.