In spite of the weight and elaborate character of this unit it was put into production in an astonishingly short space of time. The pilot mount came through on August 22, 1918, less than nine months after the spade was first struck in the ground to begin the erection of the ordnance plant. By the end of August the pilot mortar had successfully passed its firing tests at Aberdeen, functioning properly at angles of elevation from 22 degrees to 65 degrees and in any direction from the mount. While this unit was put through hurriedly for these tests, the preparation for the rest of the deliveries was made on a grand scale, looking toward quantity production later on. When the armistice was signed, every casting, forging, and structural part for every one of the 91 railway mounts was on hand and completed at the works of the Morgan Engineering Co., and thereafter the process was merely one of assembling, although in a unit of such size the assembling job alone was one of great magnitude. Even at the reduced rate of production incident to the relaxation of tension after the armistice was signed, the company delivered 45 complete units to the Government up to April 7, 1919, or five more than Gen. Pershing said he would require during the whole campaign of 1919. Careful estimates show that if the war had continued the company would have delivered the mounts at the rate of 15 per month beginning on December 15, 1918, a rate which would have completed the entire project for 91 mounts by the middle of June, 1919. As in the case of the 8-inch railway guns, the 12-inch mortars were provided with interchangeable wheel trucks allowing the unit to travel and work either on standard-gauge track or on the 60-centimeter, narrow-gauge track of the war zone in France. 14-INCH GUNS. The War Department did not have any 14-inch guns which could be spared from the seacoast defenses for use abroad. The Ordnance Department, therefore, inaugurated the project for the construction of 60 guns of 14-inch caliber. For the construction of such guns complete new plants were required, as all available facilities were already taken over for other projects considered more important. This contract was to have been turned out by the Neville Island ordnance plant. The Navy Department in May, 1918, expressed willingness to turn over to the Army certain 14-inch guns, 50 calibers, then under construction and of which it was estimated that 30 would be completed by March, 1919. It was decided to place some of these 14-inch guns on American sliding railway mounts, and 16 such mounts were ordered from the Baldwin Locomotive Works, deliveries to begin February 1, 1919. The 16 units were to be delivered prior to April, 1919, but due to the signing of the armistice work was suspended on the contracts, since the mounts were designed for use in France. The contract was canceled in March, 1919.