As a result of recommendations from French officials against production in this country during 1917 of the so-called "_obus allongé_" and the semisteel type of shell, no attempt was made to produce these for the 155-millimeter guns and howitzers during the first year of the war, but as a result of new recommendations and investigations of our officers in France in the spring of 1918 both of these types of shell were put into quantity production here. When the armistice was signed they were being turned out in such quantities that it appeared that there was sure to be an ample supply on hand in the early spring of 1919. Radical differences of manufacture existed between the French and British in the matter of specifications and methods of production. Large quantities of British ammunition had been made in this country, and we had adopted the British 8-inch howitzer, so that it appeared we should use British practice in the manufacture of shell. Manufacturers claimed that great delay would result in the production of shell here if the heat treatment and hydraulic tests were insisted upon as the French specifications called for, and investigation proved this to be essentially true, as no facilities for heat treating and hydraulic testing existed. The upshot of the entire matter was that it was decided to use French dimensions and shell for the 75-millimeter and 155-millimeter calibers so as to obtain uniformity of ballistics, but to permit American metallurgical practice to obtain in the manufacture. Shells made under these specifications were tested by the French commission in France. The verdict on these shell can be summarized in this quotation from their report: To sum up, from the test of 10,000 cartridges of 75 millimeter, it may be concluded that American ammunition is in every way comparable to French ammunition and that the two may be considered as interchangeable. Our designs for shrapnel and time fuses had been proven to be entirely satisfactory, and they were continued as they were. In fact it was generally agreed that ours was the best time fuse used on the allied side during the war. That our decision in the matter of continuing production of shrapnel and time fuses was warranted, is borne out by the fact that we obtained early deliveries in sufficient quantities to meet requirements. In the use of the adapters and boosters, which introduced an entirely new component to our service in shell making, we had had no experience, and subsequently met with great difficulties due to this lack of experience. Delays were encountered because in this part of shell manufacture it was generally necessary to await information from France whenever difficulties were encountered, or to conduct experiments before we could proceed.