The carbon dioxide may be absorbed in a tube containing soda lime (F) or in a Geissler bulb (F') containing a concentrated solution of potassium hydroxide (Note 2). The tube (F) is a glass-stoppered side-arm U-tube in which the side toward the evolution flask and one half of the other side are filled with small, dust-free lumps of soda lime of good quality (Note 3). Since soda lime contains considerable moisture, the other half of the right side of the tube is filled with small lumps of dry, dust-free calcium chloride to retain the moisture from the soda lime. Loose plugs of cotton are placed at the top of each arm and between the soda lime and the calcium chloride. The Geissler bulb (F'), if used, should be filled with potassium hydroxide solution (1 part of solid potassium hydroxide dissolved in two parts of water) until each small bulb is about two thirds full (Note 4). A small tube containing calcium chloride is connected with the Geissler bulb proper by a ground joint and should be wired to the bulb for safety. This is designed to retain any moisture from the hydroxide solution. A piece of clean, fine copper wire is so attached to the bulb that it can be hung from the hook above a balance pan, or other support. The small bottle (G) with concentrated sulphuric acid (sp. gr. 1.84) is so arranged that the tube (f) barely dips below the surface. This will prevent the absorption of water vapor by (F) or (F') and serves as an aid in regulating the flow of air through the apparatus. (H) is an aspirator bottle of about four liters capacity, filled with water; (k) is a safety tube and a means of refilling (H); (h) is a screw clamp, and (K) a U-tube filled with soda lime. [Note 1: The air current, which is subsequently drawn through the apparatus, to sweep all of the carbon dioxide into the absorption apparatus, is likely to carry with it some hydrochloric acid from the evolution flask. This acid is retained by the silver sulphate solution. The addition of concentrated sulphuric acid to this solution reduces its vapor pressure so far that very little water is carried on by the air current, and this slight amount is absorbed by the calcium chloride in (E). As the calcium chloride frequently contains a small amount of a basic material which would absorb carbon dioxide, it is necessary to pass carbon dioxide through (E) for a short time and then drive all the gas out with a dry air current for thirty minutes before use.] [Note 2: Soda-lime absorption tubes are to be preferred if a satisfactory quality of soda lime is available and the number of determinations to be made successively is small. The potash bulbs will usually permit of a larger number of successive determinations without refilling, but they require greater care in handling and in the analytical procedure.]