EXPERIMENT 72. On the lower wire leading to the electric lamp in the laboratory you will find a "gap," a place where the wire ends in a piece of a knife switch, and then begins again about an inch away in another piece of the switch, as shown in Figure 136. There must be some kind of wire or metal that will conduct electricity across this gap. But the gap is there to prevent as much electricity from flowing through as might flow through copper wire. So never put copper wire across this gap. If you do, you will have to pay for the other fuses which may blow out. Always keep a piece of fuse wire stretched across the gap. Fuse wire is a soft leadlike wire, which melts as soon as too much electricity passes through it. Unscrew the lamp, and into the socket where it was, screw the plug with the two nails sticking out of it. Turn the electricity on. Does anything happen? Turn the electricity off. Now touch the heads of the two nails together, or connect them with a piece of any metal, and turn on the electricity. What happens? Examine the pieces of the fuse wire that are left. It was so easy for the electricity to pass through the nails and wire, that it gushed through at a tremendous rate. This melted the fuse wire, or blew out the fuse. If the fuse across the gap by the socket had not been the more easily burned out, one or perhaps both of the more expensive fuses up above, where the wire comes in, would have blown out. These cost about 10 cents each to replace, while the fuse wire you burned out costs only a fraction of a cent. If there were no fuses in the laboratory wirings and you had "short circuited" the electricity (given it an easy enough path), it would have blown out the much more expensive fuses where the electricity enters the building. If there were no big fuses where the electricity enters the building, the rush of electricity would make all the copper wires through which it flowed inside the building so hot that they would melt and set fire to the building. As long as you keep a piece of fuse wire across the gap, there is no danger from short circuits. WHY FUSE WIRE MELTS. For two reasons, the fuse wire melts when ordinary wire would not. First, it has enough resistance to electricity so that if many amperes (much current) flow through, it gets heated. It has not nearly as much resistance, however, as the filament in an electric lamp or even as has the long resistance wire. It does not become white hot as they do.