The materials fittest for building furnaces are, 1. Bricks, joined together with potters clay mixed with sand and moistened with water. 2. Potters clay mingled with potsherds, moistened with water, and baked in a violent fire. 3. Iron; of which all furnaces may be made, with this precaution, that the inside be provided with a great many prominent points, as fastenings for a coat of earth, with which the internal parts of the furnace must necessarily be covered to defend it from the action of the fire. The reverberating furnace is one of those that are most employed in Chymistry: it is proper for distillations by the retort, and should be constructed in the following manner. First, the use of the ash-hole being, as was said, to give passage to the air and to receive the ashes, no bad consequence can attend its being made pretty high: it may have from twelve to twenty or twenty-four inches in heighth. Its aperture should be wide enough to admit billets of wood, when a great fire is to be made. Secondly, the ash-hole must be terminated at its upper part by an iron grate, the bars of which should be very substantial, that they may resist the action of the fire: this grate is the bottom of the fire-place, and destined to support the coals. In the lateral part of the fire-place, and nearly about the same heighth with the grate, there should be a hole of such a size that it may easily admit charcoal, as well as little tongs and shovels for managing the fire. This aperture or mouth of the fire-place should be perpendicularly over the mouth of the ash-hole. Thirdly, from six to eight or ten inches high above the grate over the ash-hole, little apertures must be made in the walls of the furnace, of eight or ten lines in diameter, an inch from one another, and those in one side must be diametrically opposite to those in the other. The use of these holes is to receive bars of iron for the retort to rest on; which should be, as I said, at different heights, in order to accommodate retorts of different sizes. At the upper extremity of this part of the furnace, which reaches from the iron bars to the top, the heighth whereof should be somewhat less than the width of the furnace, must be cut a semi-circular aperture for the neck of the retort to come through. This hole must by no means be over the doors of the fire-place and ash-hole; for then, as it gives passage to the neck of the retort, it must of course be opposite to the receiver, and in that case the receiver itself would stand over against those two apertures; which would be attended with this double inconvenience, that the receiver would not only grow very hot, but greatly embarrass the operator, whose free access to the fire-place and ash-hole would be thereby obstructed. It is proper therefore that the semi-circular cut we are speaking of be so placed that when the greatest ballons are luted to the retort they may leave an open passage to the fire-place and ash-hole.