_Balloon Wheels._--They are made to turn horizontally: they must be made two feet diameter, without any spokes, and very strong, with any number of sides. On the top of a wheel range and fix in pots, three inches diameter and seven inches high each, as many of these as there are cases on the wheel: near the bottom of each pot make a small vent; into each of these vents carry a leader from the tail of each case; load some of the pots with stars, and some with serpents, crackers, &c. As the wheels turn, the pots will successively be fired, and throw into the air a great variety of fires. BALLOON CASES. You must have an oval former, turned of smooth wood; then paste a quantity of brown or cartridge-paper, and let it lie till the paste has soaked all through; this done, rub the former with soap or grease, to prevent the paper from sticking to it; then lay the paper on in small slips, till you have made it one-third of the thickness of the shell intended. Having thus done, set it to dry; and when dry, cut it round the middle, leaving about one inch not cut, which will make the halves join much better than if quite separated. When you have some ready to join, place the halves even together, and let that dry; then lay on paper all over as before, everywhere equal. When the shell is thoroughly dry, burn a vent at top with a square iron. Shells that are designed for stars only, may be made quite round, and the thinner they are at the opening the better; for if they are too strong, the stars are apt to break at the bursting of the shell. Balloons must always be made to go easy into the mortars. MORTARS. These mortars must be made of pasteboard, with a small copper chamber at bottom, in which the powder is to be placed, on which the balloon is to be put. In the centre of the bottom of this chamber make a small hole a little down the foot: the hole must be met by another of the same size as the foot. Then putting a quick-match, or touch-string, of touch-paper, into the hole, your mortar will be ready to be fired. _To load Air Balloons with Stars, Serpents, &c., &c._--When you fill your shells, you must first put in the serpents, rains, &c., or whatever they are composed of, then the blowing powder; but the shells must not be quite filled. All those things must be put in at the fuse-hole, but marrons being too large to go in at the fuse-hole, must be put in before the inside shall be joined. When the shells are loaded, glue and drive in the fuses very tight. The number and quantities of each article for the different shells are as follows: BALLOONS ILLUMINATED. oz. Meal-powder 1 Corn-powder 0-1/2 Powder for the mortar 2 1 oz. driven or rolled stars, or as many as will fill the shell. BALLOONS OR SERPENTS. oz. Meal-powder 1 Corn-powder 1 Powder for the mortar 2-1/2