In the course of my numerous experiments upon Chimnies, I have taken much pains to determine the width proper to be given to this passage, and I have found, that, when the back of the Fire-place is of a proper width, the best width for the throat of a Chimney, when the Chimney and the Fire-place are at the usual form and size, is FOUR INCHES.--Three inches might sometimes answer, especially where the Fire-place is very small, and the Chimney good, and well situated: but as it is always of much importance to prevent those accidental puffs of smoke which are sometimes thrown into rooms by the carelessness of servants in putting on suddenly too many coals at once upon the fire, and as I found these accidents sometimes happened when the throats of Chimneys were made very narrow, I found that, upon the whole, all circumstances being well considered, and advantages and disadvantages compared and balanced, FOUR INCHES is the best width that can be given to the throat of a chimney; and this, whether the Fire-place be destined to burn wood, coals, turf, or any other fuel commonly used for heating rooms by an open fire. In Fire-places destined for heating very large halls, and where very great fires are kept up, the throat of the Chimney may, if it should be thought necessary, be made four inches and an half, or five inches wide;--but I have frequently made Fire-places for halls which have answered perfectly well where the throats of the Chimnies have not been wider than four inches. It may perhaps appear extraordinary, upon the first view of the matter, that Fire-places of such different sizes should all require the throat of the Chimney to be of the same width; but when it is considered that the CAPACITY of the throat of a Chimney does not depend on its width alone, but on its width and LENGTH taken together; and that in large Fire-places, the width of the back, and consequently the length of the throat of the Chimney, is greater than in those which are smaller, this difficulty vanishes.