Fig. 114, No. 89780 [1004_d_], is a very long hafted knife (the haft is 12.3 inches long), but otherwise resembles the type, though not so elaborately ornamented. The blade is also a bit of a saw. It is provided with a sheath 3¼ inches long, made of black sealskin with the black side out, doubled over at one side, and sewed “over and over” down the other side and round one end. To the open end is sewed a bit of thong with a slit in the end of it, into which one end of a lanyard of seal twine 15 inches long is fastened with a becket-hitch. When the sheath is fitted over the blade the lanyard is passed through a hole in the haft and made fast by two or three turns around it. Such sheaths are often used by careful workmen. This particular knife was the property of the “inlander” Ilû´bwgɐ, previously mentioned. No. 89283 [967], from Nuwŭk, is interesting as being the only left-handed tool we obtained. The fourth knife has a blade with a cutting edge of 3½ inches, while that of each of the others is 3 inches. The small knife differs little from the mĭ´dlĭñ except in having the haft very much shorter and not tapered off at the tip. Fig. 115_a_, No. 56552 [145], from Utkiavwĭñ, shows a common form of this kind of knife, though the blade usually has a sharp point like those of the large knives, projecting beyond the end of the haft. This knife has a blade of iron riveted on with two iron rivets to a haft of reindeer antler. The edges of the haft close to the blade are roughened with crosscuts to prevent slipping. The blades of the small knives are frequently inserted into a cleft in the edge of the haft, as in Fig. 115_b_, 89632 [827], and 89277 [1172]. The blade, in such cases, is secured by wedging it tightly, with sometimes the addition of a lashing of thong through a hole in the haft and round the heel of the blade. The blade is usually of steel, in most cases a bit of a saw and the haft of reindeer antler, generally plain, unless the circular hollows, such as are to be seen on No. 89277 [1172], which are very common, are intended for ornament. Fig. 116, No. 89275 [1183], from Utkiavwĭñ, is a rather peculiar knife. The haft, which is the only one seen of walrus ivory, is nearly straight, and the unusually long point of the blade is strongly bent up. The rivets are of copper. This knife, the history of which we did not obtain, was very likely meant both for wood and ivory. It is old and rusty and has been long in use. [Illustration: FIG. 115.--Small crooked knives. 1/2] [Illustration: FIG. 116.--Crooked knife. 1/3]