But prospecting is not limited to these simple surface methods. In enterprises undertaken on a large scale, borings are frequently made in regions where there are perhaps no specific surface indications. In such regions a shaft may be sunk or a tunnel may be dug, and the condition of the underlying strata thus definitely determined. This last is, of course, a most expensive method, the simpler and more usual way being that of making borings to certain depths. The difficulty with such borings is that rich veins may be passed by the borer without detection; or, on the other hand, a small vein happening to lie in the same plane as the drill may give a wrong impression as to the extent of the vein. One of the most satisfactory ways of making borings is by means of the diamond drill. This drill is made in the form of a long metal tube, the lower edge of which is made into a cutting implement by black diamonds fixed in the edge of the metal. By rotating this tube a ring is cut through the layers of rock, the solid cylinder or core of rock remaining in the hollow centre of the drill. This can be removed from time to time, the nature and thickness of the geological formation through which the drill is passing being thus definitely determined. CONDITIONS TO BE CONSIDERED IN MINING Three great problems always confront the mine operator--light, power, and ventilation. Of these ventilation is the most important from the workman's standpoint, although the problem of light is scarcely less so. Obviously a cavity of the earth where hundreds of men are constantly consuming the atmosphere and vitiating it, and where thousands of lights are burning, would become like the black hole of Calcutta in a few minutes if some means were not adopted to relieve this condition. But besides this vitiation of the atmosphere caused by the respiration of the men and the burning of lamps there are likely to be accumulations of poisonous gases in mines, that are even more dangerous. Of the two classes of dangerous gases--those that asphyxiate and those that explode or burn--it may be said in a general way that the suffocating or poisonous gases, such as carbonic acid, which is known as black damp, or choke damp, are more likely to occur in ore mines, while the explosive gases are found more frequently in coal mines. Choke damp, which is a gas considerably heavier than the atmosphere, is usually found near the bottom of mines, running along declines and falling into holes in much the same manner as a liquid. It kills by suffocation, and, as it will not support combustion, it may be detected by lowering a lighted candle into a suspected cavity, the light being extinguished at once if the gas is present. To rid the cavity of it, forced ventilation is used where possible, the gas being scattered by draughts of fresh air. If this is impracticable, and the cavity small, the choke damp may be dipped out with buckets.