The hammer strut, a small nail or the long arm of the screw driver may be used to push out all pins except the main spring cap pin and the ejector pin. To remove these a tack or pin may be found necessary. To assemble the pistol proceed in the reverse order, except that the main spring housing should be left to project about one-eighth inch. Do not push the main-spring housing home and insert the housing pin until after the safety lock is replaced and the hammer lowered. =The Operation of the Pistol.=—The act of drawing back the slide in loading cocks the hammer, compresses the recoil spring, permitting the magazine follower to raise the upper cartridge into the path of the slide. Upon releasing the slide, the recoil spring forces the slide forward, carrying the first cartridge into the chamber of the barrel. As the slide approaches its forward position, it encounters the rear end of the barrel, forcing the latter forward. Since the front of the barrel pivots in the barrel bushing and the rear end is free to swing upward on the link, the rear end of the barrel is raised, causing the locking ribs on the outside of the barrel and the inside of the slide to engage, thus positively locking the barrel and the slide together. The joint forward movement of the barrel and the slide (about three-eights of an inch) is stopped when the barrel lug encounters the pin of the slide stop. The pistol is then ready for firing. When the hammer is cocked, the hammer strut moves downward, compressing the main spring. The sear, under the action of the long leaf of the sear spring, engages its nose in the notch of the hammer. Upon pulling the trigger and pressing on the grip safety, the sear is moved, thus releasing the hammer. The latter then strikes the firing pin which transmits the blow to the primer of the cartridge. The explosion of the cartridge generates the necessary gas pressure to force the bullet through the barrel, the initial muzzle velocity being about 800 ft. per second. The pressure exerted to the rear against the face of the slide carries the latter and the barrel to the rear together. But due to the link attachment, the barrel is almost immediately swung down and unlocked from the slide, leaving the slide to continue its movement to the rear, thus opening the breech, cocking the hammer, extracting and ejecting the empty cartridge and compressing the recoil spring. When the slide reaches its rearmost position the magazine follower raises another cartridge into the path of the slide. This cartridge is then forced into the barrel by the forward movement of the slide as before described. Although it might be supposed that the downward swinging of the barrel would affect the accuracy of the fire, this is not the case. The bullet has gained its maximum velocity and passed out of the muzzle before the unlocking movement between the barrel and slide commences.