The figure [page 125] is descriptive of the cradle scythe. AEGB is the shaft. In working, it is held by the left hand with the thumb upward, near A; while the right hand holds the cross handle at H. BD is a post, making an angle of about 78 degrees with the straight line AB. Into this post the five wooden ribs, or fingers, MN, OP, QR, ST, and UV, are fixed. These are round pieces of tough wood, of a curvature resembling that of the back of the blade, as nearly as possible. They are upwards of half an inch in diameter; and are pointed at the extremities MOQSU. FG is another post, fixed in the shaft, parallel to BD, and about seven inches distant from it. ED is a thin piece of wood, let into the shaft at E, for retaining the posts BD, FG, in their positions. IK is a small round post that passes through the fingers at the distance of ten inches from the post BD. This small post passes through broad parts of the fingers, which are left so for the sake of strength, and its lower ends stands on the blade at K. The blade is such as is used in cutting hay; but the point is allowed to stand about nine inches farther out from the handle than the grass scythe. At L is a small iron bolt, rivetted into the blade, near its back; the top of this bolt passes through the lower finger, and is furnished with a hand-screw, which holds the finger down, so that its point shall remain within about half an inch of the blade. The points of the fingers MOQSU are in a straight line, but recline backward, so that the upper finger is about five inches shorter than the under one. Between {100} the posts IK, and FG, are five small connecting stays of iron. Figure 2 is a separate plan of one of the iron stays, shewing the manner in which it is fixed to the upright bars or posts. AB is a part of the finger; C the hole through which the small post (IK of the former figure) passes; and D is the post FG of the former figure. EF is the iron stay; it is about one-sixth of an inch in diameter; and it is thin and crooked near the end E, where it is fastened to the finger by two small nails. From G to F the stay is a small screw. At K, is a female hand-screw that bears against D. At H, is a nut, also bearing against the post D. By this screw the finger is firmly kept in its proper place. The fingers are five inches apart, measuring from the centre of the one to that of the other. The shaft of the scythe is five feet long, and the whole of the parts are as light as is consistent with strength.