=Parts of Fat Used for Lard Making.=--In the making of lard the highest grades are produced from the fat lining the back of the animal and that connected with the intestines. The sheets of fat which are found lining the back of the animal furnishes a variety known as leaf lard. All parts of the fat of the animal not used in the meats themselves may be used in the manufacture of lard. In the preparation of the carcass, the parts cut off in trimming the pieces and containing fat are sent to the rendering tank. The leaf lard is also removed by tearing it off from the back of the animal, and the intestinal fat is separated from the viscera in like manner. There is probably no question of wholesomeness between the lards made from different parts of the carcass. The lard differs in its chemical composition and its physical consistence as determined by its location in the body. Inasmuch as it is important that lard should have a certain degree of consistence even in summer time and not become too soft or liquid in character, the lard which has a high melting point is preferred, especially during the summer. The lards made from the feet and some other parts of the hog have lower melting points. The different kinds of fat from all parts of the animal might be mixed together and a lard made therefrom representing the average consistence of the fat of the whole body. A small quantity of stearin is often added to raise the melting point, but the addition of this substance without notice must be regarded as an adulteration. =Names of Different Kinds of Lard.=--The names applied to the different kinds of lard may be referred principally to the parts of fat used, such as leaf lard, intestinal lard, etc., or to the method of preparing it. The old-fashioned method of preparing lard for family use consisted in placing the fat in an open kettle and heating usually over the open fire. The rendering takes place as the mass increases in temperature, so that the residual tissues become browned by the high temperature reached. Lard made in this way is of most excellent quality and, of course, being made under family supervision, its character is well understood and the parts of the body used are well known. In the large packing establishments the lard is usually rendered by the application of heat in the form of steam under pressure, of a suitable temperature to make the character of lard uniform. Large yields can be secured in this way with less charring of the residual tissues, and consequently a finer and whiter color in the lard itself. Lard of this kind is sometimes known as steam rendered lard.