From a brass strip three-eighths of an inch wide and one-eighth of an inch thick cut a piece six inches long, and bore holes at either end through which long, slim, oval-headed brass screws may pass. Use brass, copper, or German-silver for this bar, and not iron or steel. To the underside, and at the middle, solder or screw fast a small block of brass, through which a hole is to be bored for the spindle or shaft. This finished bar is shown in Fig. 2. When mounted over the magnet and held down with brass screws driven into the wood base, its end view will appear as shown in Fig. 3, A being the bar, B B the screws which hold it down, D the base into which they are driven, and C C the blocks under the magnet (N S). The object of this bar is to support one end of the armature shaft. From brass one-eighth of an inch thick bend and form two angles, as shown at Fig. 4. Two holes for screws are to be drilled in the part that rests on the base, and one hole, for the shaft to pass through, is bored near the top of the upright plate. The centre of this last hole must be the same height from the base as is the hole in the bar (Fig. 2) when mounted over the magnet, as shown at Fig. 3. The location of these plates is shown in the plan (Fig. 10). There is one plate at each end of the base, as indicated at B and B B, the shaft passing through the hole in the brass block at the underside of the bar (C). These angles are the end-bearings for the armature shaft, and should be accurately centred so that the armature will be properly centred between the N and S bars of the magnet. [Illustration: FIG. 1 FIG. 2 FIG. 3 FIG. 4 FIG. 5 FIG. 6 FIG. 7 FIG. 8 FIG. 9 DETAILS OF UNI-DIRECTION DYNAMO] The armature is made from soft, round iron rod one inch and a half in diameter and five inches long. A channel is cut all around it, lengthwise, five-eighths of an inch wide and half an inch deep, as shown in Fig. 5. This will have to be done at a machine-shop in a short bed-planer, since it would be a long and tedious job to cut it out with a hack-saw. The sharp corners should be rounded off from the central lug, so that they will not cut the strands of fine wire that are to be wound round it. Two brass disks, or washers, are to be cut, one inch and a half in diameter and from one-eighth to one-quarter of an inch thick, for the armature ends. A quarter-inch hole is to be made in the centre of each for the shaft to fit in, and two smaller holes must be drilled near the edge, and opposite each other, so that machine-screws may pass through them and into holes bored and threaded in the ends of the armature, as shown at Fig. 5. These ends will appear as shown at Fig. 6, and the middle hole should be threaded so as to receive the end of a shaft. When the shaft is screwed in tight the end that passes through the brass disk must be tapped with a light hammer to rivet the end, and so insure that the shaft will not unscrew.