German-silver wire is wound on the wooden roller, one end having been made fast to the metal collar; and when all the thread grooves on the wood roller are filled the opposite end of the wire is attached to the rear end of the metal roller. The current entering at binding-post No. 1 crosses on the strip of spring metal to the collar, travels along the coil of wire, and crosses to the metal roller and is conducted out at binding-post No. 2 (see Fig. 15). If the resistance is too great slip the handle over the end of the metal roller and give it several turns. The current will then pass with greater freedom as the wire on the wooden roller becomes shorter. This may be readily seen by connecting a small lamp in series with a battery and this rheostat. As the metal cylinder is turned the current flows more freely and the filament becomes red, then white, and finally burns to its full capacity. Take care, however, not to admit too much current as it will burn out the lamp. Some sort of adjustment should be made to prevent the rollers turning of themselves and thus allowing the wire coils to slacken. This may be done by boring the two holes for the rollers to fit in and then, with a key-hole saw, cutting the stick as shown at C in Fig. 16, taking care not to split it at the ends. The result will be a long slot which, however, has nothing to do with the bearings. Down through the middle of the stick make a hole with an awl, so that the screw-eye will move easily in the upper half but will hold in the lower half. Under the head of the eye place a small copper washer; then with the thumb and finger drive the screw-eye down until the head rests on the washer. A slight turn of the eye when it is in the right place will draw the upper and lower parts of the stick together and bind the wood about the bearing ends of the rollers. The rollers should not be held too tightly as that would strain the wire when winding it from one to the other. It should be just tight enough to keep the wire taut. Two or more of these roller resistance-frames may be made and connected in series so that a close adjustment can be had when using battery currents for experimenting. Liquid Resistance Apart from metallic, mercurial, or carbon resistance a form of liquid apparatus is frequently used in laboratory and light experimental work. [Illustration: _=Fig. 17=_] [Illustration: _=Fig. 19=_]