In Fig. 10 an interior section is shown, which when once understood will be found extremely simple. The block (A) is of pine, white-wood, birch, or cherry, and is two inches and three-quarters square and five-eighths or three-quarters of an inch thick. A hole seven-eighths of an inch in diameter is bored in the centre of this block, half an inch deep, and a path is cut at the face of the block one inch and a half in diameter and one-eighth of an inch deep. Be careful to cut these holes accurately and smoothly, and if it is not possible to do so, it would be well to have them put in a lathe and turned out. The face-plate (B) is two inches square, with a three-quarter-inch hole in it, and the under-side is cut away for one-eighth of an inch in depth and one inch and a half in diameter. The object of these depressions in block A and face-plate B is to give space for the diaphragm (D) to vibrate when the voice falls on it through the mouth-piece (C). From carbon one-eighth of an inch in thickness two round buttons are cut measuring three-quarters of an inch across. A small hole is bored in the centre of each button, and one of them is provided with a very small brass screw and nut, as shown at F F. One side of the button-hole is countersunk, so that the head of the screw will fit down into it and be flush with the face of the carbon. With a small three-cornered or square file cut the surface of the buttons with criss-cross lines, as shown at F F. When the buttons are mounted in the receiver these surfaces will face each other. Cut a small washer from felt or flannel, and place it in the bottom of the hole in block A. Line the side of the hole with a narrow strip of the same goods; then place the button (F F) in the hole, pass the screw through the hole and through the block (A), and make it fast with the nut, as shown at F. Place a thin, flat washer under the nut, and twist a fine piece of insulated copper wire between washer and nut for terminal connections, taking care that the end of the wire under the nut is bare and bright, so that perfect contact is assured. Since the practice of telephony involves such delicate and sensitive vibratory and electrical phenomena, it is best to solder all joints and unions wherever practicable, and so avoid the possibility of loose connections or corrosion of united wires.