For this we will need a tile, a pad, a broad flat brush (Fig. 173), some turpentine, capavia, two tubes of paint—one copper-water green, the other brown green—a palette-knife, and some pieces of cotton cloth. Now be sure your china is perfectly clean and dry, then mix your copper-water green for =Tinting.= Place enough color on your palette to cover the entire surface to be tinted; dip your palette-knife in the capavia oil and tap it off the knife on the tile; in the same way place turpentine on the tile with the oil, and use your palette-knife to _thoroughly_ mix the paint, oil, and turpentine. If the mixture seems too stiff add a little more oil and turpentine, but be careful not to have the paint too thin so that it will run; test its consistency with a brush on a clean place on the tile. As a rule, the proportions for tinting should be five drops of paint to three of capavia, mixed with a little turpentine. The paint being prepared, take the flat brush and begin to paint; rapidly cover the entire surface with color. Then go over the tinting with a pad, touching lightly and gently, not letting the pad rest a moment on the paint, nor touching it twice in the same place in succession. Continue going over and over it until the grounding is even and of a uniform tint. Then set the china away to dry, in a safe place, where it will be free from dust. Always make a fresh pad every time you tint, and a separate one for each color used, as a pad cannot do service more than once. All tinted grounds and borders are made in this way, the capavia oil and turpentine being mixed with any of the grounding colors you may wish to use. Tinting is very easily and quickly done; but should anything happen to spot or mar the evenness of the grounding, the paint must all be washed off with turpentine, and the china tinted over again. When your green-tinted china is perfectly dry, gather some maple leaves and with the brown-green paint try a =New Method of Decorating China.=