Mines treated in this way, if kept in a dry storehouse, and not put in the water, should not require repainting for several years. Frequent inspection should be made, however, for in handling the cases and changing their positions on the racks, it will often happen that an abrasion will be made in the surface of the paint, which if neglected may serve as the starting point of a progressive corrosion, which may extend rapidly under the surface of the paint. Should loose paint or rust be seen the case should be repainted. A small wooden mallet may be used to tap the case at all points to loosen scales of rust or paint; then the surface should be thoroughly wire brushed or scraped and the cases repainted as stated above. The inside of mine cases must be inspected to see that the interior surfaces are kept free from rust. Ground mines and ground mine buoys should be treated in the manner just described for buoyant mine cases. If the oil engine has not been painted, it should be given a priming coat of red lead mixed in oil. This should be rubbed down with pumice stone and two coats of steel-colored paint applied. The second coat should be rubbed down and two coats of varnish then applied. After this the engine should not need repainting for a couple of years. When, however, repainting is necessary, the engine should be rubbed down until all the varnish is removed and a coat of steel-colored paint applied. This coat should be rubbed until no brush marks remain, and one or two coats of varnish should then be applied. The steel-colored paint should be applied flat; that is, the color which is ground in Japan should be mixed with turpentine. One gallon of this paint is more than sufficient to give an engine two coats. The motor-generators and the casemate transformers usually will not need the priming coat of red lead, as they come from the factory painted. When it is necessary to paint them, one coat of the steel-colored paint and one of varnish will usually be found sufficient. Anchors, distribution boxes, junction boxes, mooring sockets, shackles, sister hooks, and the ironwork of operating boards and power panels should be painted with asphaltum varnish. Paint brushes when new, and before use, should be wrapped or bridled with strong twine and soaked in water to swell. After use they should be cleaned with turpentine and put away in water to keep them from drying and becoming unpliable.