The breech-block is a steel cylinder having heavy screw-sectors about its surface to correspond with those in the seat. The last turn of screw-thread is left entire in order to relieve the shock of closing the breech. The forward face is made movable in order that when it becomes worn and scored by the action of the powder-gas it may be changed. This face is a steel disc which sets flat against the face of the block, and is of the same diameter. It seats in the face of the block by means of a smaller cylinder or trunnion, and projecting from the rear of this trunnion is a steel rod, which passes completely through the axis of the block and carries the vent. In order to prevent the disc from having any independent motion, a small tenon on its rear face enters a socket in the face of the block. The disc is keyed fast by a small pin which is screwed radially through the block near the middle, the end of the pin taking in a score cut in the vent-rod. A small catch, projecting from the rear lower side of the block, holds the console in place when the breech is closed. The rear face of the block is provided with two parallel handles screwed to it, to assist in moving it, and a long crank-handle between them for revolving the block. At the end of this crank-handle there is a slight projection made to receive the blows of any instrument that may be used to drive the block around when it works stiffly. Along the two lower blanks of the block slots are cut, in which traverse small projections of the console to hold the block steady. About the middle of the lower screw-sector a small hole is cut into which a small stop springs when the block is withdrawn to its limit on the console. The vent is provided with a copper bush at its forward end and a steel one at its rear. The console is semi-cylindrical, and is hinged to the face of the breech so that when the breech-block is withdrawn it may be swung to the right and unmask the bore. It is provided with a spring stop and two small projections taking in the block, which limit the movement of the latter and hold it steady when resting on the console. Two small pins, screwed into the face of the breech, limit the arc of movement of the crank-handle, one at the vertical point and the other 60° to the right. A small stop attached to the face of the breech holds the crank-handle fast when the breech is closed. This stop allows the handle to pass in closing, but must be raised by hand in opening.