_Schlickeysen's Machine._[26]--This machine has been in use in Germany since 1860, in the preparation of peat. It appears to have been originally constructed for the working and moulding of clay for making bricks. The principle of its operation is identical with that of Weber's process. The peat is finely pulverized, worked into a homogenous mass, and moulded into suitable forms. Like Gysser's machine, it forces the peat under some pressure through a nozzle, or, in the larger kinds through several nozzles, whence it issues in a continuous block or pipe that is cut off in proper lengths, either by hand or by mechanism It consists of a vertical cylinder, through the axis of which revolves a shaft, whereon are fastened the blades, whose edges cut and whose winding figure forces down the peat. The blades are arranged nearly, but not exactly, in a true spiral; the effect is therefore that they act unequally upon the mass, and thus mix and divide it more perfectly. No blades or projections are affixed to the interior of the cylinder. Above, where the peat enters into a flaring hopper, is a scraper, that prevents adhesion to the sides and gives downward propulsion to the peat. The blades are, by this construction, very strong, and not liable to injury from small stones or roots, and effectually reduce the toughest and most compact peat. Furthermore, addition of water is not only unnecessary in any case, but the peat may be advantageously air-dried to a considerable extent before it enters the machine. Wet peat is, indeed, worked with less expenditure of power; but the moulded peats are then so soft as to require much care in the handling, and must be spread out in single courses, as they will not bear to be placed one upon another. Peat, that is somewhat dry, though requiring more power to work, leaves the machine in blocks that can be piled up on edge and upon each other, six or eight high, without difficulty, and require, of course, less time for curing. The cut, (fig. 18), represents one of Schlickeysen's portable peat-mills, with elevator for feeding, from which an idea of the pulverizing arrangements may be gathered. In Livonia, near Pernan, according to Leo, two of Schlickeysen's machines, No. 6, were put in operation upon a purely fibrous peat. They were driven by an engine of 12 horse-power. The peat was plowed, once harrowed, then carted directly to the hopper of the machine. These two machines, with 26 men and 4 horses, produced daily 60,000 peats = 7500 cubic feet. 100 cubic feet of these peats were equal in heating effect to 130 cubic feet of fir-wood, and cost but two-thirds as much. The peats were extremely hard, and dried in a few days sufficiently for use. In 1864, five large Schlickeysen machines were in operation at one establishment at St. Miskolz, in Hungary. The smaller sizes of Schlickeysen's machine are easily-portable, and adapted for horse or hand-power.