In the gas-puddling furnace, or in the ordinary reverberatory, impure peat may, however, be employed, since the ashes do not come in contact with the metal. The only disadvantage in the use of peat in these furnaces is, that the grates require cleaning more frequently, which interrupts the fire, and, according to Tunner, increases the consumption of fuel 8 to 10 _per cent._, and diminishes the amount of metal that can be turned out in a given time by the same quantity. Notwithstanding the interruption of work, it has been found, at Rothburga, in Austria, that by substitution of machine-made and kiln-dried peat for wood in the gas-puddling furnace, a saving of 50 _per cent._ in the cost of bar iron was effected, in 1860. What is to the point, in estimating the economy of peat, is the fact that while 6.2 cubic feet of dry fir-wood were required to produce 100 lbs. of crude bar, this quantity of iron could be puddled with 4.3 cubic feet of peat. In the gas furnace, a second blast of air is thrown into the flame, effecting its complete combustion; Dellvik asserts, that at Lesjoeforss, in Sweden, 100 lbs. of kiln-dried peat are equal to 197 lbs. of kiln-dried wood in heavy forging. In an ordinary fire, the peat would be less effective from the escape of unburned carbon in the smoke. In other metallurgical and manufacturing operations where flame is required, as well as in those which are not inconvenienced by the ingredients of its ash, it is obvious that peat can be employed when circumstances conspire to render its use economical. 17.--_Peat as a source of illuminating gas._ Prof Pettenkofer, of Munich, was the first to succeed in making illuminating gas from wood; and peat, when operated according to his method, furnishes also a gas of good quality, though somewhat inferior to wood-gas in illuminating power. It is essential, that well-dried peat be employed, and the waste heat from the retorts may serve in part, at least, for the drying. The retorts must be of a good conducting material; therefore cast iron is better than clay. They are made of the [symbol: D] form, and must be relatively larger than those used for coal. A retort of two feet width, one foot depth, and 8 to 9 feet length, must receive but 100 lbs. of peat at a charge. The quantity of gas yielded in a given time, is much greater than from bituminous coal. From retorts of the size just named, 8000 to 9000 cubic feet of gas are delivered in 24 hours. The exit pipes must, therefore, be large, not less than 5 to 6 inches, and the coolers must be much more effective than is needful for coal gas, in order to separate from it the tarry matters. The number of retorts requisite to furnish a given volume of gas, is much less than in the manufacture from coal. On the other hand, the dimensions of the furnace are considerably greater, because the consumption of fuel must be more rapid, in order to supply the heat, which is carried off by the copious formation of gas.