There is no record of the visit of any other steamboat to Plymouth until the advent of the General Lafayette, in 1828. She was built in New York in 1824, and bought in Boston by James Bartlett, Jr., James Spooner and Jacob Covington, with the view of establishing a steamboat line between Plymouth and Boston. According to her enrolment in the Plymouth Custom House, issued September 16, 1828, her name was General Lafayette, with one deck, two masts, 82 feet, 7 inches long, 6 feet, 1 inch deep, and measured 92 54-95 tons. For her better accommodation the owners of the boat bought Jackson’s wharf at the foot of North street, and contracted with Jacob and Abner S. Taylor to build at the end of the wharf an extension nine hundred feet long and twenty-eight feet wide with a T at the end projecting northwesterly one hundred feet square. The extension built of piles and timber and plank was not completed until the autumn of 1828. In the meantime the Lafayette ran through the summer of that year from Hedge’s wharf, leaving Plymouth at hours when the tide served, and leaving Boston at hours which on her arrival would enable her to reach her dock. Of course her fuel was wood, and she made the passage in five hours, making about eight and one-half statute miles per hour. The point reached by the wharf was that point on what was called the Town Guzzle, where at mean low tide there were four or five feet of water. With that depth of water a small steamboat like the General Lafayette could reach the extreme end of the wharf at all times of tide. The Town Guzzle was a circuitous one. It left Broad channel at its extreme southwesterly end, and running southwesterly five or six hundred feet, it made an easy curve; thence running northwesterly about eight hundred feet, and thence with another easy curve running southwesterly about four hundred feet to a point reached by the wharf. It was perhaps forty feet wide, and with sufficient water beyond that width for the dip of paddle wheels, at any time except within an hour of low water, there was rarely any detention. Steamboats of moderate length found little difficulty in rounding the curves, but those of greater length found it anything but easy work. I remember once the steamboat Connecticut left the wharf at near low tide, with a spring line from her bow to the wharf to twitch her round the curve, and as the line tautened, it snapped, the hither end coming back like a whip lash and tripping up, without serious injury, about a dozen persons standing near the cap log. I learned the lesson then and there to always stand at a distance from a spring line.