Practical Hand Book of Gas, Oil and Steam Engines: Stationary, Marine, Traction; Gas Burners, Oil Burners, Etc.; Farm, Traction, Automobile, Locomotive; A simple, practical and comprehensive book on the construction, operation and repair of all kinds of engines. Dealing with the various parts in detail and the various types of engines and also the use of different kinds of fuel.Rathbun, John B.
Science
Practical Hand Book of Gas, Oil and Steam Engines: Stationary, Marine, Traction; Gas Burners, Oil Burners, Etc.; Farm, Traction, Automobile, Locomotive; A simple, practical and comprehensive book on the construction, operation and repair of all kinds of engines. Dealing with the various parts in detail and the various types of engines and also the use of different kinds of fuel.
Rathbun, John B.
Internal combustion engines; Traction-engines
(3.) By leaving the plug in its present position and deflecting the
fresh gas to meet it.
(4.) By changing the location of the inlet port.
[Illustration:
Fig. 58-a. Two Cylinder Marine Engine, of the Two Stroke Type. Built
by Fairbanks-Morse and Company.
]
In the motor invented and described by Mr. Jenkins, the method given by
(4) is adopted as shown by Fig. 66, in which the spark plug is placed at
the point of admission of the gas and in a confined passage. The
operation of the motor is as follows:
Carbureted gas is drawn into crank-case from the carburetor (not shown)
in the usual manner, i. e., by the upward movement of the piston; and by
its downward movement is forced through the rectangular port in the wall
of the piston into the combustion passage within the water-jacket when
the port in the piston wall registers with the lower end of this
combustion passage, and drives ahead of it the bad gas remaining after
the previous explosion. If the throttle is wide open the combustion
space above the piston will be completely filled, and on the ignition of
the charge the maximum pressure will be exerted on the piston. If,
however, the throttle is but slightly open, the combustion passage only
may be filled and none overflow into the combustion space above the
piston. This small charge will be just as efficient in proportion to its
volume as was the large charge, for it was compressed to practically the
same extent and none was mixed with the bad gas of the previous
explosion. It will, therefore, be obvious that the spark-plug is always
swept by the fresh charge, be it large or small, and the ignition will
be just as certain in one case as in the other, although the charge and
consequent impulse may be only just sufficient to keep the engine
turning over, and without missing a single explosion.
[Illustration:
Fig. 64-d. Roberts Cylinder Showing Cellular Screen in the Intake
Port. This Screen Prevents Crank Case Fires by Chilling the Cylinder
Flame Before it Enters the Crank Case.
]
In the motor built to test and demonstrate this design, provision was
made for a second spark-plug to be located in the top of the cylinder
for speed work, if this was found necessary. No opportunity has yet been
had for making track tests, though without regret, as this two-cycle
motor will run idle without missing or “stuttering,” which was the thing
heretofore impossible.
CHAPTER VII
OIL ENGINES
(31) Diesel Oil Engine.
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Elsewhere in the archive
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account