An “opposed” type engine is in the most perfect mechanical balance of any engine as the crank shafts and connecting rods are not only on opposite sides of the crank-shaft, but make equal angles with the center line of the cylinders as well, at all points in the revolution. The explosive impulses occur at equal angles in the revolution as in the four and six cylinder vertical type. An opposed engine may be considered as a “V” having a cylinder angle of 180°. In the opposed type, one crank throw is provided for each cylinder, the pistons of the opposite cylinders traveling in opposite directions at the same time. A “radial” or “Fan” type motor, as the name would suggest has the cylinders arranged in one or two rows around the crank case, each cylinder being on a radial line passing through the center of the cylinder with one crank throw for each row. The Gnome engine illustrated elsewhere in the book is an example of this type, the seven equally spaced cylinders acting on a common crank throw. When more than seven cylinders are used on this engine, as in the fourteen cylinder engine, two cranks are provided, each crank serving seven cylinders. This arrangement cuts down the weight of a motor enormously because of the short crank shaft and case. With the ignition properly timed and the cylinders correctly spaced the firing impulses occur at equal angles. “Tandem” cylinders are employed only on stationary engines, the cylinders being placed on the same center line, one in front of the other, and when this arrangement is adopted it is the usual practice to make the cylinders double acting. The two pistons are connected by a rod known as the “piston rod” which extends from the rear end of one cylinder into the front of the following cylinder. Tandem cylinders require too much room for use on automobiles or motor boats, and for this reason are seldom seen in this service. The “twin” engine is a modification of the vertical cylinder arrangement, both cylinders being on the same side of the shaft and in line with one another. It is the type most generally used on very large stationary engines that have more than one cylinder, and instead of being vertical as in their prototype are generally laid horizontally. Since the twin engine is generally double acting, the crank throws are placed on opposite sides of the shaft. (45) Four Cylinder Vertical Auto Motor. A common type of four cylinder vertical motor is shown by Fig. 19, which is of the type commonly used on automobiles. In order to show the general construction of the cylinder, each cylinder is cut through at a different point. The cylinder at the extreme left is shown in elevation, or as we would see it from the outside. In the second cylinder from the left, the section is taken through the valve chamber, which projects from the side of the cylinder. A section through the center of the cylinder is shown on the third cylinder, and the fourth cylinder is in elevation.