These four series of samples were taken at the four corners of a square twelve feet on a side and serve to show how much samples may vary in that distance. The large difference shown in III, A is due to the fact that the soil tube penetrated a hole left by the decay of a rather large root as shown by the bark in the sample. =77. Auger for Taking Samples.=—It has already been said that the ordinary auger used for boring fence post-holes may be used to advantage in taking soil samples. Large wood augers can also be used to advantage for the same purpose. For special purposes, however, other forms of augers may be used. Norwacki and Borchardt[61] have described a new auger for taking samples of soil for analytical purposes. [Illustration: FIGURE 12. ] In figure 12, A, B and C show the general exterior and interior form of the instrument. The handle is hollow and made of iron gas pipe covered with leather. On the inside of this, in the middle, is fixed a wooden plug a, which leaves two compartments, one in each end for holding the brass plug bb,’ and the wicker lubricating wad cc.’ The stem of the auger a, is heavy and made of eight-sided steel and the under end is strengthened with a heavy casting fitting into the auger guide g g. The end of the auger I I′ is triangular and hardened. The auger guide g g, is made out of a single piece of drawn steel tubing. Above it is strengthened by a ring-shaped piece of iron or copper and its lower end is furnished with saw teeth as shown in K and is hardened. The fixing key e, is bent in the form of a hook and can be passed through the two holes o o, of the auger stem and through the one hole o′ in the strengthened part of the auger guide. It permits the auger guide to be fixed upon the auger stem in two different positions, higher and lower. On one end it is cut squarely across and on the other provided with a conical hole drilled into it. It fits on the one hand exactly in the auger guide and on the other loosely plays in the cavity of the handle at b, designed to hold it when not in use. The cap d′ is made of heavy sheet brass and is fastened upon the end of the handle at c c′ after the manner of a bayonet. The wicker cartridge is made of rolled and sewed wicker-work. At the upper end it is provided with a metallic button and before use it is saturated with paraffin oil. It fits on the one side firmly in the auger guide and on the other in the cavity, of the handle c where it is kept when not in use. The union h is made of a brass tube which below is closed with a piece of solid brass upon the inside of which a hole is bored. In this hole rests the end of the auger stem when the union is placed firmly upon the auger guide.