(_Proctor & Schwartz, Inc., Philadelphia._)] The skins to be dried are placed on poles which in turn are set on the horizontal conveyors as in Fig. 11. As the skins pass through the compartments, large volumes of air, heated to the required temperature over the steam coils, are circulated among the skins by means of the fans. Exhaust fans, properly placed, remove a certain quantity of moisture-laden air when it has accomplished its full measure of work. When the skins on the conveyors have passed the full length of the dryer, they are entirely dry, and are then removed from the poles. (Fig. 12). The time required for drying varies according to the nature of the fur from 1–2 hours to 6–8 hours. In tests made to determine the relative efficiency of the conveyor type of dryer as against the old “loft” method, it was found that there was a saving of over 50% in power, and of 85% in floor space, as well as a great saving of labor, when the conveyor system was used, the number of skins dried in a given period of time being the same in both cases. The advantages of the new method are easily apparent, and the saving is sufficiently great with large lots of furs, to make an appreciable difference in the final cost of dressing. If the skins have been dried by a modern drying system they all come out in a uniform condition, and are ready to go on immediately to the next operation. If, however, a form of the “loft” method of drying has been used, it is customary to subject the skins to an additional process. The dried pelts are put in drums with damp sawdust, and drummed for a short time in order to get them into the proper condition. The drumming is essential for the purpose of equalizing the condition of the pelts, some being drier than others, and as a consequence of the contact with the moist sawdust, they are all brought to the same degree of dryness. As a result of this operation also, the skins become considerably softened. [Illustration: FIG. 12. DELIVERY END OF CONVEYOR DRYER. (_Proctor & Schwartz, Inc., Philadelphia._)] Then if the pelts have not been previously oiled during the tanning process, or prior to the drying, they receive this treatment now. The oil or fat is applied to the leather side of the furs, which are then placed in the tramping machine for a short time in order to cause the oil to be forced into the skin. The fibres of the corium thus become coated with a thin layer of fatty material, which contributes greatly to the softness and flexibility of the pelt, and increases its resistance to the action of water, and also, in certain instances a partial chamois tan is produced, thereby improving the quality of the leather. [Illustration: FIG. 13. STRETCHING MACHINE FOR CASED SKINS. (_Reliable Machine Works, Evergreen, L. I._)]