It was quite a step forward when a certain fur dyer, possessing a little more courage, or perhaps, experimenting spirit than the others, attempted to dye furs by dipping them entirely into a bath containing a solution of the dye instead of applying a paste as formerly. The advantages to be gained by such a method of dyeing were many. A large number of skins could be treated thus at one time, and this was a very important consideration in view of the great increase in the demand for dyed furs. By allowing the furs to remain in the dye solution until the proper shade was obtained, the time and labor of applying many coats of dye by brush was considerably reduced, and in addition, there was a greater probability of the products coming out all alike, uniformly dyed. The results as far as the hair was concerned, were indeed highly gratifying, but the condition of the leather after dyeing was not so encouraging. This difficulty has to a considerable degree been overcome, although there are frequent instances of the leather being affected by the dyeing process even with modern methods. However, the remedy in such cases, or rather the preventative is the proper dressing of the skins prior to the dyeing. The dip method of dyeing has acquired great importance, and is being employed in dyeing operations involving the handling of millions of skins annually. In certain instances, nevertheless, the brush method is of prime significance as in the dyeing of seal, and seal imitations on muskrat and coney, enormous quantities of furs being dyed in this fashion. In the majority of imitations dyed, both the brush and the dip methods must be used. Figure 19 illustrates the various types of brushes which are used at the present time for the application of the dye by the brush method. Each brush has a specific purpose and use. The procedure in brush dyeing is somewhat as follows. The skins, after being properly treated, that is, killed, and mordanted, are placed on a table, or work-bench, hair-side up. Then by means of a brush which is adapted to the nature and requirements of the particular fur, the solution is brushed on in the direction of the fall of the hair, occasionally beating gently with the brush so as to cause the dye to penetrate to the desired depth. Considerable skill and care must be exercised in this operation as it is rather easy to force the dye down further than is wanted, and in some cases the leather or the roots of the hair may be affected. The skin having received its coat of dye, is then dried and finished, if no other dyeing processes are to be applied. Frequently, with certain types of dyes, several applications of color are necessary, and these are brushed on as the first one, drying each time. Then, on the other hand, the skin may receive a dyeing in the bath by dipping, and for this also, the fur is first dried after the brush dyeing. [Illustration: FIG. 19. BRUSHES USED IN FUR DYEING BY THE BRUSH METHOD.]