To the lower jaw, A, of a pair of tongs is pivoted a platen or bed, B, having a hole through its center, which is continued through the jaw for the passage of the drillings. The upper jaw is formed with a circular flange on which is mounted the circular or disk-like base, C, of the drill frame, D. This, with the frame, is secured on the jaw of the tongs by means of two screw bolts--one seen in the engraving--passing through the jaw and screwing into the base of the drill. These bolts pass through semi-circular or segmental slots, by which the drill frame can be swung around at different angles to the tongs, to adapt itself to the convenience of the workman and the requirements of the work. If desired, the crank by which the drill is driven may be used on the upright spindle, E. It will be seen that the pivoted base or bed, B, will allow the work to adapt itself always to the line of the drill. In operation, the work being placed between the drill and platen, the left hand presses the handles of the tongs together, while the right turns the crank; the feed is thus graduated wholly by the pressure of the hand. No further description is required for understanding the construction or operation of this tool. Patented by F. Nevergold and George Stackhouse, June 19, 1866. Applications for the whole right, or for territorial rights, should be addressed to the latter at Pittsburgh, Pa. * * * * * COMMISSIONER OF AGRICULTURE.--The Senate on Friday, the 29th ult., confirmed the nomination of the Hon. Horace Capron as Commissioner of Agriculture to fill the position made vacant by the death of Isaac Newton, the former head of the Department. * * * * * It is estimated that 10,000,000 feet of sawed lumber is frozen up in the docks at Bangor, Maine, three fourths of which is sold and waiting shipment. * * * * * Correspondence _The Editors are not responsible for the opinions expressed by their correspondents._ Improved Method of Securing Cutters on Boring Bars. MESSRS. EDITORS:--Thinking it may be of use to some of the readers of your invaluable paper, I have taken the liberty of sending you a sketch of a new mode of securing the cutter in a boring bar or pin drill. Where the cutters are secured, as usual, by a key, all mechanics know that it is very difficult to set a cutter twice alike; and the notch, which is filed in the cutter, to prevent it from moving endways, is a great source of weakness, often causing the cutters to crack in hardening, as well as after they are put to work. The inclosed sketch will explain itself: [Illustration]