To Make an Unoccupied Bed Remove pillows and bedclothes, one at a time, being careful not to let corners drag on the floor, and put to air. Turn the mattress over from end to end one day, and from side to side next day. If the patient does not have to return to bed at once leave to air for at least half an hour. An old blanket, old spread or a quilted pad, spread over the mattress not only protects the mattress but prevents the sheets from wearing out, and may make the bed more comfortable. These should be kept clean. The bed for a sick person is frequently made with a rubber sheet and a draw sheet. The draw sheet is so called because its proper use is to be drawn through under the patient without greatly disturbing her and give her a cool fresh place to lie on. Therefore it should be long enough to tuck in sufficiently under one side to allow of this being done. An ordinary sheet folded in two from top to bottom and placed with folded edge toward the head of the bed may be used. It should entirely cover the rubber sheet, which is usually put on between the bottom and the draw sheet. [Illustration] When the mattress is sufficiently aired, put on the protective covering. Over this spread the lower sheet so that the middle fold of the sheet lies up and down the centre of the mattress from head to foot. Keep perfectly straight. The sheet should be long enough to have at least fourteen inches over at ends and sides to tuck in. Tuck ends under mattress at head and foot drawing tightly so that it will be smooth and firm. Now tuck under at one side, folding neatly at corners, so that they will be mitred when finished. If there is no rubber nor draw sheet to put on, go to the other side of the bed and tuck in firmly at corners. Then, pulling the middle of the sheet very tightly with one hand, push the mattress with the other and tuck the sheet under. This under sheet should be very smooth without a wrinkle in it. If it is not long enough to tuck in well at both head and foot, leave plenty at the head to tuck in securely and tuck in at the sides tightly rather than risk having it come loose at the head. Be sure, however, that the mattress is entirely covered. When Rubber and Draw Sheets Are Used Before going around to the other side, lay the rubber sheet over the bed, so that the top edge will be well above where the lower edge of the pillow will come. Put the draw sheet over it. Tuck both well under the mattress on that side. Then, go to the other side and tuck in the corners of the lower sheet as directed, then stretching draw, rubber, and under sheet very tightly, tuck in separately.