Soap-Making Manual: A Practical Handbook on the Raw Materials, Their Manipulation, Analysis and Control in the Modern Soap Plant.Thomssen, Edgar George
Science
Soap-Making Manual: A Practical Handbook on the Raw Materials, Their Manipulation, Analysis and Control in the Modern Soap Plant.
Thomssen, Edgar George
Soap
To proceed, first run into the crutcher the tallow, cocoanut oil and
bayberry wax when used, and bring the temperature of the mass up to
140deg.-160deg. F. by dry steam. Then add the caustic soda lye and keep on
heat with occasional mixing until it is all taken up. When this stage is
reached gradually add all but about 5 per cent. of the potash lye, and
complete the saponification. This point having been reached, the heat is
turned off; the crutcher is run and the stearic acid, previously melted
by dry steam in a lead-lined or enameled vessel, is run in in a
continuous stream and the crutching continued for fifteen minutes to
half an hour. Samples are taken at this time, cooled and tested by
alcoholic phenolphthalein solution. If too alkaline more stearic acid is
added, if too acid more potash lye from that previously reserved. After
each addition of lye or stearic acid the mass is crutched from 10 to 15
minutes longer, another sample is taken, cooled and again tested. When
the phenolphthalein shows a very light pink after several minutes, the
soap is practically neutral, although at this point one can better judge
by dissolving a sample in hot neutralized alcohol made by putting into
the alcohol a few drops of phenolphthalein, and then adding weak alkali
drop by drop from a burette until a slight pink, not yellow, tint is
obtained, and noting the color of the solution. The solution should show
a very light pink when the soap is properly neutralized. When this stage
is arrived at the gum tragacanth, previously softened in water, is
crutched in if it is to be added. The soap is then framed, stripped in
three or four days, dried and milled.
The formulae as given are for shaving sticks, and do not readily press
unless thoroughly dried. A more satisfactory result is obtained by
adding at the mill 25 per cent. of white tallow base to obtain a
satisfactory mug soap.
SHAVING POWDER.
Shaving powder differs from the soaps just described in being
pulverized, usually adding up to 5 per cent. starch to prevent caking.
Any of the above soaps, dried bone dry, with or without the addition of
tallow base make a satisfactory powder for shaving.
SHAVING CREAM.
Shaving cream is now a very popular shaving medium due to the rapidity
and convenience with which one can shave by the use of this product.
Formerly shaving cream was made from the liquid oils like olive oil and
a soft fat like lard, together with cocoanut oil. Now, however, most of
the popular shaving creams are made from stearic acid and cocoanut oil,
as a far superior product is obtained by the use of these substances. By
using these a more satisfactory cream is obtained, and it is far more
convenient to make. The lather also produced therefrom is more suitable
for shaving, being thick, creamy and remaining moist.
A few typical formulae for shaving creams of this type are as follows:
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Elsewhere in the archive
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account