_Barrel Stand._--A simple and effective barrel stand may be made in the manner described below. It consists of a stout frame on 4 legs 9-12 in. high, made of quartering which may vary from 2 in. sq. for small casks to 3 in. sq. for larger ones. The proportions given in the annexed illustration (Fig. 67) are suited to a 9 gal. cask. This should be 22 in. long, 15 in. wide, 9 in. high, and made of 2½ in. stuff, of which it will consume about 9½ ft. run. It will be seen that the sides _a_, _b_ are joined to the legs _c_, _d_, _e_, _f_ by mortice and tenon joints, while the ends _g_, _h_ are dovetailed into the sides _a_, _b_. The joints are secured by pins of oak or red deal driven into holes bored by a gimlet. The stand thus made is only adapted to carry casks stood on end. For holding them steadily on their side, and at the same time giving them a tilt forward to allow all the clear contents lying above the sediment to be drawn out without disturbing the barrel, use is made of 2 pieces of board hollowed out to receive the barrel. For the sized cask mentioned (9 gal.), 15 in. will suffice in length and 1 in. in thickness for each piece. Both are prepared for letting down into the frame by cutting out a piece 2½ in. sq. from each of the 2 bottom corners as at _a_, and can then be screwed to the cross piece _b_ of the frame. Previously the cradle is formed by describing on the piece of wood an arc of a circle corresponding to the size of the cask at the point where it is to be supported. Supposing the diameter of the cask to be 15½ in., the radius of the circle to be described will be 7¾ in., as shown. This gives the correct arc, but as the cask will lie sloping and not flat, the foremost edge of the arc must be shaved away till the cask will rest on the entire breadth of the edges of the cradle _c_. For the front cradle the board may be 6½ in. wide, and for the back 8½ in.