as the must can run off below, on the outside and also on the inside. The cost of mill and press is about $90, but each can be had separately for $45. If a large amount of grapes are to be pressed, the press should be of much larger dimensions, but may be constructed on the same principle--a strong, large platform, with a strong screw coming through the middle, and a frame made of laths, screwed to a strong wooden frame, through which the must can run off freely, with another frame around the outside of the platform. The must runs off through grooves to the lower side, where it is let off by a spout. It may be large enough to contain a hundred bushels of grapes at a single pressing, for a great deal depends upon the ability of the vintner to press a large amount just at the proper time, when the must has fermented on the husks just as long as he desires it to do. FERMENTING VATS. These should correspond somewhat with the size of the casks we intend to fill; but they are somewhat unhandy if they hold more than, say four hundred gallons. They are made of oak or white pine boards, 1-1/2 inch thick, bound securely by iron hoops, about three feet high, and, say, five feet wide. The bottom and inside must be worked clean and smooth, to facilitate washing. When the must is to ferment a longer time on the husks, as is often the case in red wines, a false bottom should be provided, for the purpose of holding the husks down below the surface of the must. It is made to fit the size of the vat, and perforated with holes, and held in its place by sticks of two inches square, let into the bottom of the vat, and which go through the false bottom. A hole is bored through them, and the bottom held down by means of a peg passed through this hole. The vat is closed by a tight-fitting cover, through which a hole is bored, large enough to admit a tin tube of about an inch in diameter, to let off the gas. The vats are set high enough above the ground to admit drawing off the must through a faucet near the bottom of the vat. For those grapes which are to be pressed immediately we need no false bottoms or covers for the vats. As fermentation generally progresses very rapidly here, and it is not desirable with most of our wines to ferment them on the husks very long, as they generally have astringency enough, operations here are much more simple than in Europe. The must is generally allowed to run into a large funnel, filled with oat straw, and passes through a hose into the casks in the cellar. A hole can be left through the arch for that purpose, as it is much more convenient than to carry the must in buckets from the press into the casks. It is sometimes desirable to stem the grapes, although it is seldom practiced in this country. This can be easily done by passing the bunches rapidly over a grooved board, made somewhat in the form of a common washboard, only the grooves should be round at the bottom and the edges on top. It is seldom desirable here.