The advantage of using this taper half-round reamer is the hole is made perfectly round, and at the same time the taper of the reamer gives a bevel to the hole that forms a good, strong and effective cutting edge. With a file cut out a portion of the tool of a V shape, bevelling the edges the same as the hole as shown in Fig. 67. This V may be either cut on the end, a side of the tool, as shown, but in use it is preferred to be cut on the side, as then, if necessary, the hand can find a hold on that end to assist it in operating. When done, temper for use. For the cherry, turn a piece of steel in the lathe to fit a chuck. Half-inch octagon is perhaps the best size of steel from which to make cherries of less diameter than half-inch, and the length about six inches. The end on which the cherry is to be made is roughly fashioned into a ball, leaving the end where the centre supports it to be removed by the lathe tool or by filing. [Illustration: FIGURE 68.] When fitted so that the rough blank will be held firmly in the chuck, run the lathe at moderate speed, set the T rest so that the steel die can be held on it about level with the under side of the rotating blank. On the rest lay the die, and press the opening so as to receive the rough sphere, applying oil and not pressing too hard. Let it gradually scrape its way through the circular aperture, the V-shaped opening in the side receiving the stem to which the cherry is attached. In Fig. 68 is shown the finished blank after being passed through the die. If it be preferred the die may be held in the hands and not supported on the T rest. Take care to supply plenty of oil to the work, as this will prevent scratching or tearing the cherry while being formed. It is well to make two of these holes, one at each end of the piece of steel, roughing the blank with the first, which is a little larger than the one used to finish the cherry of the exact size. When this tool gets dull grind on the upper or cutting edge, but not too much, as it will enlarge the hole, and the result will be to make a larger cherry. To form these blanks into cutting tools, a copy can be taken from the cherries as sold to the trade. Bear in mind to leave the grooves deep enough to receive the metal cut from the blank mould when in operation. [Illustration: FIGURE 69.] It will be observed that the cherries as purchased (Fig. 69) do not have their cutting edges terminate in that portion of the mould, but usually on one side. This is done to insure a perfectly spherical form by having a cutting side operating at the bottom of the hole while it is being formed. It is somewhat difficult to make this form of cutting edge, and some patience and care must be exercised or the blank may be spoiled.