For crayon work the stones must be uniform and hard. They must either be new, or, if they have been used, they must be ground so thoroughly that all traces of fat are destroyed and removed absolutely to a degree where it is certain that they will not appear again and take color, even if the stone is etched only lightly. As soon as the plates have been ground true, they must be grained by strewing some fine sand or powdered sandstone on them and rubbing in all directions with a small piece of limestone. The work can be done dry or wet. Soap-water is best. It gives the stone a handsome grain. Practice is demanded to get good results without scratching the stone. The artist must decide for himself what grain he needs. I think that it would be good if the artist himself were to grain the stone in varying degrees according to the need of his design. For instance, a coarser grain might be good for foregrounds. As soon as the stone has been grained, it must be cleansed perfectly from dust and dirt. It is best to pour clean water over it and wash it with a clean rag. The dust and sand must all be removed, otherwise they will not let the crayon reach the stone where it is used delicately. When the design is finished, it should be set aside for a day, that it may take good hold of the stone. It does no harm to let plates rest for years before etching. Etching must be done by pouring. Painting the etching fluid on is dangerous because of the danger of taking away fine spots. About one hundred parts of water are used to one part of aquafortis. Everything depends on not etching a bit more than necessary. It is best to etch the coarser parts specially with a small brush and stronger etching solution, and it is very good to wash the stone with clean water after etching and let it dry completely before coating with gum. When the stone has been prepared, it should not be cleansed at once with oil of turpentine, but should be inked-in first with a light printing-color. Only after it has taken this well should it be cleansed of the crayon and treated to a firmer color. In the first inking-in there should be very little pressure with the sponge or wet cloth when dampening it, as the lightest parts of the design are easily rubbed away before they have taken color. If such parts should vanish, the easiest way to restore them is as follows:-- Coat the plate with gum solution and wipe with a clean dry cloth till it is perfectly dry. Then take a flat, knife-like instrument of steel, which is cleanly ground so that it has no nicks or other defects that might injure the stone. Scrape with moderate pressure to and fro over the defective places, but only so that it touches the elevated points and not the surface of the stone itself. Smear a little fat, such as linseed oil varnish, over it and wash this away again instantly with gum solution. Generally the parts all reappear very nicely when the stone is inked-in again.