The planking of the roadway rests on double beams, supported at several points in the manner shown in the woodcut, each point having suspension-rods to connect it with the nearest angles of the frames. The arrangement of the double polygonal frame and of the tie-rods enables the transverse strength of the timbers to exercise considerable resistance to any distortion of the shape of the truss by a rolling load. To prevent any tendency of the top of the frame to yield sideways under the compressive strain, the tops of the trusses are connected by transverse struts or braces, the two outside trusses being steadied by raking ties attached to outriggers projecting from below the flooring of the bridge. The thrust of the polygonal frames is resisted by wrought-iron tie-bars at the level of the roadway beams. All the tie-rods in this bridge are double, with one bar on each side of the timbers, to avoid the necessity of making large bolt-holes.[90] The viaduct at Newport consists of eleven spans with queen trusses, resting on piles. The main span, over the river Usk, is 100 feet, and was constructed with timber trusses very similar to those at Landore. Shortly before it was finished, the viaduct was burnt down. In rebuilding it, wrought-iron trusses were employed for the main span. * * * * * The works of the Cornwall Railway were commenced in the year 1852. The district through which the line passes is very deficient in the materials requisite for the construction of a railway. The granite of the country is for the most part only applicable for ashlar; and the slate, which is flat-bedded and so far fit for rubble masonry, is frequently inferior in quality. In consequence of the number of valleys that the railway had to cross, the aggregate length of the viaducts, thirty-four in number, exclusive of the Saltash bridge, is upwards of four miles on a line of sixty miles. By the use of timber, a great saving was effected in the first cost of the works; and though it is a material which in time requires renewal, its use on the Cornwall Railway enabled the line to be made with the capital at the command of the Company; while, allowing for the cost of subsequent repairs, the total expenditure did not differ much from what it would have been had the superstructure of the viaducts been of more durable materials. The comparatively small cost of these structures enables them to be, in certain places, economically substituted for embankments, as was done on the Cornwall Railway. The viaducts are to be found over the whole length of the line, but they are most frequent between the Liskeard and Bodmin Road stations, where the railway crosses numerous branches of the Glynn valley. Most of these viaducts are of one type of construction.