Subsequent improvements in the facilities for bending wrought-iron plates enabled him to use a form of cross section of wrought-iron girder, the top flange of which was a nearly circular tube, the best shape of strut to resist longitudinal compression. It is shown in the woodcut (fig. 7), and was used in many of his bridges. This form was afterwards modified to that shown in fig. 8. The semicircular top plate is stiffened by occasional cross diaphragms, and while it was a good form to resist compression, it was more easily painted than the closed-in top flanges shown in figs. 6 and 7. The forms of wrought-iron girder already referred to are those known as plate girders, with continuous webs made of plates riveted together, and therefore analogous to the beams of cast iron which they almost entirely superseded. On Mr. Brunel’s railways there are a great number of bridges of these forms of girder, where the spans do not exceed 100 feet. For larger spans he used wrought iron, in large and deep trussed frames, by which means a great degree of economy was attained in the employment of the material. [Illustration: _Scale of feet._ Fig. 8. Girder on Eastern Bengal Railway, 92 feet span. _Transverse Section._] The care which he had taken to satisfy himself of the action of the strains in plate girders was of service in all the greater structures he designed, as in all of them he employed wrought-iron girders to carry the roadway, of a type somewhat similar to those already described, the girders being supported at frequent intervals by the main framework or truss. _Opening Bridges._ The first large opening bridge which Mr. Brunel constructed was a roadway swing bridge, 12 feet wide, across the new lock at the Bristol Docks. The length of the overhanging end is 88 feet, and the other, or tail end, which is 34 feet long, rests upon two wheels, which travel on a circular rail. The weight of the overhanging end is rather more than counterbalanced by large blocks of cast iron, forming part of the pavement of the tail end. Almost the whole weight is borne on a centre pivot, assisted by four wheels in fixed bearings, upon which runs an inverted circular rail attached to the underside of the bridge. On the pivot, which rests on a large cast-iron bed-plate, are two discs, one of steel and the other of brass, which can readily be lubricated, or taken out and renewed. [Illustration: _Scale of feet._ Fig. 9. Cumberland Basin Swing Bridge.]