First there is the cacao cake crusher (figs. 85a and 85b), which reduces the pressed cake into rather large pieces about the size of a walnut, previous to its being pulverised either in the melangeur, centrifugal sifting machine or some similar apparatus. It has been furnished with one (fig. 85a) and in some cases even with two (fig. 85b) pair of toothed or cogged rollers, and the cacao in this latter type of construction is crushed as small as a pea, which reduction, although it is by no means essential, considerably relieves the strain on the pulverising machine and is also in some sort a protection against unnecessary waste of material. [Illustration: Fig. 87.] Then again, there is the so-called pulveriser shown in fig. 86. This is in principle an edge-mill with revolving bed-stone and runners, both made of granite. The coarsely broken press cakes are fed into the mill through a hopper provided with a slide, and are reduced to a loose powder of firmly fixed colour, escape of dust being prevented by the hood fitted to the mill. By turning a crank, a lateral sliding door is opened, and an arrangement inside is set in motion, by which the ground cacao is turned out of the mill. The pressure of the runners can be diminished and even completely nullified. For cacao that has been thoroughly defatted (“dry” cocoa), the hardness of which demands a more efficient treatment than is possible in these machines, they being only calculated to press or at the most exert a rubbing effect, there are the crushers proper, called mills built in pulverising plants for dry cocoas as illustrated on fig. 87. The pressed cacao, already broken up to some extent in a preliminary crusher (cf. figs. 85a and b), is systematically conducted through the mill by an elevator provided with hopper and feeding apparatus. On the interior of the machine, which is completely plated with steel-plates, there is a cross-arm as on a windmill, which passes through a large number of revolutions per minute. Chiefly owing to its thrashing effect, the cacao in the mill is fine ground, without any rubbing or exertion of pressure as in the melangeur and other machines. The outer part of the frame consists of a grating with various widths of hole, which can be readily changed. The whole of the powder which has attained a certain degree of fineness falls through these meshes and is so despatched from the machine at once, an additional advantage when comparing this mill with the melangeur, in which all the powder, even that sufficiently ground, must remain till the final discharging, much to the detriment of its flavour and aroma. [Illustration: Fig. 88.]