In order to render the starch more easily gelatinisable, the fat is first removed by treating 5 grammes of cocoa powder or 10 grammes of a cacao preparation with ether and then with an 80% solution of alcohol to separate any sugar, theobromine and cacao red. The residue is then mixed with water and subjected to a steam pressure of from three to four atmospheres, which converts the starch into a soluble body known as amylo-dextrine. This operation is generally carried out in an autoclave or strong copper vessel[182] provided with an air-tight and removable cover, the open flask, containing the sample to be gelatinised (1 part of cacao and 20 parts of water) being placed in the vessel half immersed in water. After screwing on the lid, the temperature of the interior of the vessel is raised to 133-144° C. corresponding to a pressure of 4 atmospheres, and maintained at that pressure for three or four hours in order to allow the action to proceed on the mass for gelatinisation of the starch. The flask is then removed from the apparatus and the contents allowed to settle for a few minutes; the liquid is filtered hot, the filtrate amounting to about 250 or 300 ccm after the filter has been washed a few times with hot water. Only the cell fibre remains on the filter, whilst the starch is dissolved in the filtrate. This is now heated with 20 ccm of hydrochloric acid in a flask connected with a reflux condenser, whereby the starch is converted into dextrose. The sugar solution is neutralised with sodium carbonate, clarified with basic lead acetate, any excess of the latter being removed with sodium sulphate, finally filtered, and the whole made up to 500 ccm. The sugar is determined in this solution by titration with alkaline copper sulphate solution and from the number of cubic centimetres required for the precipitation of the red cuprous oxide, the quantity of sugar can be ascertained. As 99 parts of starch are equal to 108 parts of dextrose or grape sugar, the following calculation must be made. dextrose starch {dextrose} = { }:x. 108:99 { found } In the determination of sugar with copper sulphate it is more advantageous to follow up F. Allihin’s[183] method, in which the cuprous oxide is reduced by hydrogen gas to metallic copper, weighed as such, and so the sugar calculated, or the cuprous oxide can be collected on an asbestos filter and weighed in that condition. The cuprous oxide must be previously washed with hot water, alcohol and ether, which must be completely removed by subsequent drying in the air bath, since an error of even 1 milligramme would seriously affect the final result. Then again, the amount of sugar may be determined by polarisation, a process which has also its own particular advantages.