20 grammes of fine divided chocolate are loosely introduced into a Soxhlet’s extracting apparatus, and there extracted with ether for a period of 16 hours. Of the residue, 10 grammes are used for testing in connection with caseine, and this after the ether has evaporated. These are mixed up in mortar with gradual and even addition of a 1% solution of sodium oxalate, so that no lump formations occur, and then brought into a marked carboy of 250 ccm capacity, until 200 ccm of the sodium oxalate solution have been used. The carboy is then provided with an asbestos net, and heated by means of a flame from the under side, until its contents are brought to boil. The mouth of the carboy is covered with a small funnel which has been hermetically sealed at its narrower end. Then boiling oxalate solution is poured into the vessel up the bend, and it is then allowed to stand over till another day, shaking however being often repeated, then filled with sodium oxalate solution up to the mark, agitated with a regular motion, and then filtered through an ordinary filter. To 100 ccm of this solution 5 ccm of an uranous acetate solution (5% strong) and drop by drop and with repeated stirring a 30% solution of acetic are added until there is a deposit. (This will require from 30 to 120 drops, according to the amount of caseine present.) Then an extra 5 drops of acetic acid can be added. This causes the deposit to stand out clearly from the liquid matter and it can be readily separated by centrifugalising. Afterwards it can be washed out with 100 ccm of solution, of which 5 ccm are uranous acetate and 3 ccm acetic acid 3 % strong, until the sodium oxalate can no longer be seen on adding calcium chloride (i. e. after about three repeated centrifugalisations). The contents of the tube are then rinsed on to the small filter by means of the wash fluid, stirred in a Kjeldahl carboy with concentrated sulphuric acid and copper oxide, and the quantity of nitrogen found converted into caseine by multiplying with the factor k = 6·37.—Bearing in mind the quantity of fat, the percentage of caseine in the original chocolate is calculated.[203] In the following: b = signifies the total of fatty content of the chocolate[204], a = the Reichert-Meissl number of the total fat, and K = the amount of caseine as established by the Laxa-Baier method (nitrogen contents times 6·37). (a - 1) b Further: 1. The desired quantity of fat 1. F = ————————- equal is to the R.M.N. a, of the total fat 27 less that of the cacao fat (1·0) multiplied by the total amount of fat and divided by the average R.M.N. for butter fats = 27.